Table of Contents
Advertisement
Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
8 Disassembly and assembly / 8.7 Installing cartridge group
© Copyright 2020 . All rights reserved.
Attach lifting gear to lifting device (90190) and turn compressor cas-
u
ing (72000).
Fit O-ring (42012) to bearing casing.
u
By hand, screw on three press-off nuts (61090), equally spaced
u
around circumference, up to ends of threads of bearing casing studs.
Push compressor casing (72000) onto cartridge group to fit snugly
u
and fasten using nuts (61037).
Secure three press-off nuts (61090) against compressor casing
u
(72000) by tightening to specified torque. (See chapter Table of tight-
ening torques.)
Remove lifting device (90190).
u
Measure and note the axial clearance (A) (see the section on axial
u
clearance).
CAUTION
Clearances out of tolerance
Clearances out of tolerance and excessively worn components can be
the cause of serious damage to machinery and property.
Have components assessed and, if necessary, replaced by an ABB
u
Turbocharging Service Station.
Connect oil lines and all air lines in accordance with engine builder's
u
instructions.
Version with compressor wheel cooling system
Fit the air supply line. (Also see the chapter Preliminary remarks / Lay-
u
out and functioning.)
Fit the filter silencer or air suction branch.
u
Fit the insulation.
u
HZTL2498_EN
Rev.F
December 2020
Advertisement
Table of Contents
