Table of Contents
Advertisement
Connecting the cables
To connect the LCD monitor to your system, please follow these instructions:
NOTE:
Make sure to read "Recommended Use" before installation.
In order to display the maximum resolution, a display controller that can output a resolution of 1536 x 2048 for
MD212G3 and 2048 x 2560 for MD211G5 is needed.
1. Turn off the computer.
2. DVI connection: Connect the DVI signal cable to the connector of the display controller in your system (Figure A.1).
Tighten all screws.
DisplayPort connection: Connect the DisplayPort cable to the connector of the display controller in your system
(Figure A.2).
Figure A.1
NOTE:
1. Please use a DisplayPort cable with a DisplayPort logo.
2. When removing the DisplayPort cable, hold down the top button to release the lock.
3. Remove the cable cover (Figure B).
To remove the cable cover, unlock the slide latch (1) on the cable cover (2) and slide the cover to the side to remove it.
4. Connect all cables to the appropriate connectors (Figure C).
NOTE:
1. Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module
and/or shorten the module's life.
2. For re-calibration and display management, the USB cable shipped with the display must be connected with a
USB 2.0 port of the computer as well. For connection details please refer to page 10.
Back of the display
DisplayPort cable
Figure B
Computer
Figure C
English-8
Figure A.2
Slide latch
Cable cover
AC IN
To the wall outlet
Advertisement
Table of Contents
