Advertisement
Quick Links
Short Leg
on Right
Retainer for
Ceiling Mounted
Projector
CLEANING. Small amounts of dust and wipe marks are very
noticeable on lens surfaces with a high brightness projection beam but
typically will not impact the image as much as damage from excessive
cleaning in pursuit of a "perfect" optical surface. Occasionally blowing
off the lens surfaces with clean air is the best way to maintain long
term performance. If there is any excessive residue or build-up then it
is recommended that you clean the optics with professional lens
cleaning supplies such as from a camera store while the lens is in front
of the lit beam of the projector. This will allow you to quickly see if the
cleaning process is causing any damage.
LIMITED WARRANTY. Panamorph, Inc. warrants this product against
any change in performance or functionality for a period of twenty-four
months from our ship date. During this period, a unit may be repaired
or replaced, at the discretion of Panamorph, Inc., by returning it in its
original packaging with a copy of your receipt. This warranty does not
cover damage resultant from lack of prudent care, accident or misuse
(including use with other products in ways not intended); any cosmetic
damage not reported within 15 days of purchase; or any performance
change caused by the environment in which it is used. All damages are
limited to the cost of the product. This warranty is not transferable.
Short Leg
on Left
Retainer for
Projector Mounted
on a High Shelf
CDR-E1 Installation Guide Version 1.0
We bring cinema home
CDR-E1
Direct Attach Cinema Format Conversion Lens
INSTALLATION GUIDE
(Phillips #2 screwdriver required)
For use only with the
IMPORTANT THEATER GUIDANCE
1. Projection screen should be
minimum 2.0" screen border.
2. Projector lens center should be between -2 and +6 inches from
the top edge of the screen surface (about +3 inches is ideal) and
horizontally centered on the screen +/- 3 inches.
3.
Throw ratio
(throw distance divided by screen surface width) should
be at least 1.4:1.
4.
Edge curvature / distortion
throw ratios so longer throw distances are encouraged. The screen
border should be used to mask edge curvature of about 1.5" at a 1.4:1
throw ratio; about
1" at 1.6:1
; with
distortion visible as throw ratio increases. If desired, use the
Epson LS12000 "Point Correction" for final distortion adjustments
and then
"Panel Alignment"
only after finalizing lens setup.
Patent Pending
®
Epson LS12000
projector
flat
, in the
2.4:1
aspect ratio and with a
of the image is most noticeable at low
progressively less edge
Advertisement
Related Manuals for Panamorph CDR-E1
Summary of Contents for Panamorph CDR-E1
- Page 1 Edge curvature / distortion of the image is most noticeable at low or replaced, at the discretion of Panamorph, Inc., by returning it in its throw ratios so longer throw distances are encouraged. The screen original packaging with a copy of your receipt. This warranty does not border should be used to mask edge curvature of about 1.5”...
- Page 2 CDR-E1 Installation Steps INSTALL THE PROPER LENS RETAINER. Remove the two front Phillips assembly screws and remove the rear retainer. Assembly Use this retainer for a ceiling-mounted projector. Use the other Screws retainer provided for a high shelf-mounted projector (see illustration on reverse).