Related Manuals for GE Fluorostar
Summary of Contents for GE Fluorostar
- Page 1 GE Healthcare ™® Fluorostar 00-441130-01 IPC1000 BIOS Setup with integrated PC-guard support for IPC 1000 Radisys Endura JD35Q IPC 1000 (0,5k x 0,5k ) 00-453962-01 and higher IPC 1000 (1k x 1k) 00-453963-01 and higher Version 09.12.03...
- Page 2 This document contains advanced service information that is company confidential. Due to the proprietary nature of the contents the document should be viewed by GE personnel only. This manual may not be reproduced, in whole or in part, without the written permission of GE OEC Medical Systems, Inc.
- Page 3 VERSUCHEN SIE NICHT, DAS GERÄT ZU REPARIEREN, BEVOR DIESES KUNDENDIENST-HANDBUCH NICHT ZU RATE GEZOGEN UND VERSTANDEN WURDE. • WIRD DIESE WARNUNG NICHT BEACHTET, SO KANN ES ZU VERLETZUNGEN DES KUNDENDIENSTTECHNIKERS, DES BEDIENERS ODER DES PATIENTEN DURCH ELEKTRISCHE SCHLÄGE, MECHANISCHE ODER SONSTIGE GEFAHREN KOMMEN. • ESTE MANUAL DE SERVICIO SÓLO EXISTE EN INGLÉS. AVISO •...
- Page 4 00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential • IL PRESENTE MANUALE DI MANUTENSIONE É DISPONIBILE SOLTANTO IN INGLESE. AVVERTENZA • SE UN ADDETTO ALL MANUTENSIONE ESTERNO ALL GEMS RICHIEDE IL MANUALE IN UNA LINGUA DIVERSA, IL CLIENTE É TENUTO A PROVVEDERE DEIRETTAMENTE ALLA TRADUZIONE. •...
- Page 5 00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential Preparation Open the front cover od the system. Set on IPC1000 PC-Guard to OFF Figure 1 PC Guard ON/OFF Connect a keyboard to the system To enter BIOS Setup press “DEL” while IPC1000 is booting. You can see then BIOS screens on main monitor A. Tipp: On Compact and on Compact Dual (without installed B392) it can happen that you don’t see the Boot Screen.
- Page 6 00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential Notice: After replacing BIOS battery clear RTC RAM before setting the BIOS setup Clear RTC RAM (CLRTC) The CLRTC jumper allows you to clear the Real Time Clock (RTC) RAM in CMOS. You can clear the CMOS memory of date , time and system setup parameters by erasing the CMOS RTC RAM data.
- Page 7 00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential Figure 2 Jumper JRTC1 Page 7 of 13...
-
Page 8: Native Mode Operation
00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential 1. MAIN 1.1 System Time [08:29:03] (Set to actual time) 1.2 System Date [01.09.2009] (Set to actual date) 1.3 Hard Disk Pre-Delay [Disabled] 1.4 Serial ATA [Enabled] 1.5 Native Mode Operation [Auto] SATE RAID Enable [Disabled] SATA AHCI Enable [Enabled]... -
Page 9: Boot Features
00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential 2. ADVANCED 2.1 Boot Features Quiet Boot [Enabledl] Quick Boot Mode [Enabledl] ACPI Mode [Yes] ACPI Sleep Mode [S1] High Precision Event Timer [Yes] Power Button Behavior [4-sec Override] Resume on Modem Ring [Off] Resume on PME# [On] PS2 KB/MS Wake Up [Disabled]... -
Page 10: Advanced Chipset Control
00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential 2.3 Advanced Chipset Control Integrated Device Control Sub Menu USB Host Controller [Enabled] Memory Reclaiming [Enabled] Enable VT-d [Disabled] Default Primary Video Adapter [PEG] IGD-Device 2 [Disabled] Azalia Audio [Auto] Route Port 80h cycles to [PCI] 2.4 Memory Cache Cache System BIOS area... -
Page 11: I/O Device Configuration
00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential PCIE x1 Slot 4 Option ROM Scan [Disabled] Enable Master [Disabled] Latency Timer [Default] PCIE x4 Slot 5 PCI Express Port #5 [Auto] Option ROM Scan [Enabled] Enable Master [Disabled] Latency Timer [Default] PCIE x16 Slot 7 PCI Express Graphics Port [Auto] PEG Port Enabled... -
Page 12: Hardware Monitor
00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential Mode [Normal] Base I/O address [2F8] Interrupt [IRQ 3] Parallel Port [Enabled] Base I/O address [378] Interrupt [IRQ 7] Mode [ECP] DMA Channel [DMA 3] 2.7 Hardware Monitor CPU Temperature Threshold [75°C] Fan Speed Control Modes [Disable (Full speed)] 3. -
Page 13: Reboot System
00-441130-01_IPC1000 BIOS Setup_Radisys_Endura_JD35Q.doc Company Confidential 6. Reboot system Set PC-Guard to ON and reboot system. 6. Used keys Select Screen Select Item Enter Go to Sub Screen General Help Setup defaults F 10 Save and Exit EXIT Page 13 of 13...