Table of Contents
Advertisement
NC1500C
3.4
Adjusting the primary lens
Display the test pattern and adjust the screen size, focus and screen position with the
primary lens.
3.4.1
Display the test pattern
Press the MENU button of the remote controller.
[1]
"TITLE SELECT" is displayed on the LCD screen at the projector side.
Press ▼ button.
[2]
Press the < / > buttons to select "TEST PATTERN".
[3]
Press the < / > buttons to select "Cross Hatch".
[4]
Press ▼ button.
[5]
Press "ENTER" button.
[6]
An (*) will be put on the selected test pattern.
3.4.2
Adjusting the screen ratio
Adjust the screen ratio of the primary lens here. Adjust the screen ratio of the anamorphic
lens after adjusting the primary lens screen ratio and mounting the anamorphic lens (See
D-33).
When an anamorphic lens is used, distortions will be produced on the projection screen. To
prevent the image from being cut off due to these distortions, the image size should be
made larger than the screen size beforehand.
To minimize potential distortions of the anamorphic lens, it is recommended that the lens
shift not be used as much as you can and that projection be kept at lens center.
• How to Call the Lens Center
Memo
［1］Press the "MENU" button on the remote control panel.
［2］the Configuration menu using the arrow buttons "< / >".
［3］Press the " " button.
［4］Select "Installation" using the "＜/＞" buttons.
［5］Press the " " button.
［6 Select "Lens Center" using the "＜/＞" buttons.
［7］Press the " " button.
［8］When "Move" appears on the display, press the "ENTER" button.
"Title SELECT" appears on the projector's LC display.
The lens will begin to move.
3. Projector Adjustment and Connection
D-31
Advertisement
Table of Contents
