Environmental Temperature Humidity Safety United States Canada CE Marking 2/01 EPSON PowerLite 703c Projector 1:1.2 42 dB ±15° (maximum) UHE (Ultra High Efficiency) About 1000 hours ELPLP14 32.8 feet (10 meters) Alkaline AA (2) 2.8 to 3.4 inches (72 to 87 mm) 8.4 inches (213 mm)
74.93 MAC21 75.062 NTSC SECAM The image is resized so that it displays using one of the projector’s native formats. EPSON PowerLite 703c Projector Computer Connector Pin Assignments The Computer/Component video port is a female video RGB, 15-pin micro-D-style connector. The pin assignments are:...
7 to 9 ft 3.6 to 4.3 ft If you place the projector below the level of the screen, you’ll have to tilt it up by extending the feet as shown. Tilting the projector upward causes the image to lose its square shape, but you can correct the distortion by pressing the button as described in the next chapter.
Page 4
Power Power button The power light flashes green as the projector warms up, and the projection lamp comes on in about 30 seconds. The power light stays green. Warning: Never look into the lens when the lamp is on. This can damage your eyes, and is especially dangerous for children.
If the projected image isn’t square or has a “keystone” shape, do one or more of the following: ❏ If your image looks like projector off to one side of the screen, at an angle. Move it directly in front of the center of the screen, facing the screen squarely.
The remote control lets you access all of your projector’s features from anywhere in the room (up to 30 feet away). You can use it to turn the projector on and off, zoom the image, and highlight your presentation, for example.
Enter Use the Enter button to navigate the menus or to use (pointer the remote as a mouse pointer when the projector is button) connected to a computer with the mouse cable. The Enter button acts as a mouse left-click.
(such as an artist’s camel-hair brush). If the dirt is difficult to remove or if the filter is torn, replace it. Contact your dealer or EPSON to obtain a new one. 4. To replace the filter, use a small screwdriver to pry it off.