Assembly - Baofeng UV-5RV2+ Operating Manual
Dual band/dual display radio
Hide thumbs
Also See for UV-5RV2+:
- Operating manual (74 pages) ,
- Operating manual (59 pages) ,
- Operating manual (23 pages)
Table of Contents
Advertisement
Antenna
This device is fitted with a Male SMA connector. To mount the antenna (Female SMA Connector),
align the two connectors and turn the antenna clockwise until it stops.
When installing the antenna, install it by holding the base and turning.
If an external antenna is used, ensure that the 'SWR' is about 1.5:1 or less to avoid damage
to the transceiver's transistors.
Holding the antenna with your hand or wrapping the outside may cause subpar operation
of the transceiver.
Never transmit from the device without an antenna.
Belt Clip
On the back of the radio, above the battery, there are two parallel screws. Remove these and
align them so that they go through the holes on the belt clip as they are screwed back into the
radio body to securely affix the belt clip.
Install the belt clip at the rear of the battery compartment cover as shown in the figure to the
right.
Do not use glue to affix the screws onto the battery clip. Application of glue may cause
damage to the casing of the battery.
http://www.baofengradio.us
Assembly
http://baofengradio.us
10
- Quick Links:
- Getting to Know the Radio
- Manual Programming
Hide quick links:
Advertisement
Table of Contents
