DC-777 システム例 :カメラアダプター と組み合わせる場合 カラーアダプターDC-777から電源の供給を受けて、 カ ラーカメ ラ ◆ 接続についてはカメ ラアダプターDC-777の取扱説明書も あわせて ご覧く ださい。 モジュールから映像信号を取り出します。 DC IN/VIDEO 端子( ピン) カラービデオカメラモジュール XC-777A カメラケーブル CCXC-12P05S/D/U/L CAMERA 端子 ( ピン) DC-777 カメラアダプター GENLOCK IN VIDEO OUT CAMERA ~ AC IN VD/VBS VIDEO S VIDEO 電源...
Page 27
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful Model No. XC-777A/777AP Serial No. interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful...
Page 28
VORSICHT AVERTISSEMENT Um Feuergefahr und die Gefahr eines elektrischen Afin d’éviter tout risque d’incendie ou d’électrocution, ne Schlages zu vermeiden, darf das Gerät weder Regen noch pas exposer cet appareil à la pluie ou à l’humidité. Feuchtigkeit ausgesetzt werden. Pour les utilisateurs au Canada Für Kunden in Deutschland Cet appareil numérique de la classe A est conforme à...
Page 29
Precautions ..............31 Location and Function of Parts ........32 This manual applies to both the XC-777A and XC- XC-777A/777AP CCD Color Video Camera Module ..32 777AP. The operating instructions for color video cameras are the same, but their signal systems and camera Installation ..............
Features The XC-777A/777AP is an ultra-small CCD color video Four white balance adjustment modes camera module which uses a CCD (Charge Coupled Device), a solid stage image sensor. You can choose the white balance mode according to the lighting conditions by setting the WHITE BALANCE switches.
They may damage the surface finish, or • Near a TV or radio station that radiates high-powered impair the operation of the camera. radio frequencies In the event of any problems with the operation of the camera, contact your Sony service representative.
Location and Function of Parts XC-777A/777AP CCD Color Video Camera Module 1 WHITE BALANCE 2 SHUTTER speed 3 AGC ON/OFF 1 DIP switches for setting functions 4 Y/C / VBS 2 R control for manual white balance adjustment 3 B control for manual white balance adjustment 1 ·...
Page 33
1 WHITE BALANCE speed. Select the white balance setting according to the lighting Shutter speed DIP switch setting conditions. 1/60 sec. (XC-777A) or Lighting condition DIP switch setting 1/50 sec. (XC-777AP) (factory setting) 1 · · · · 6 For indoor shooting...
Page 34
Location and Function of Parts 3 AGC (auto gain control) ON/OFF 2 R control for manual white balance adjustment This control is effective when the white balance switches Gain DIP switch setting are set to MAN. Adjust the red color by turning the control with the supplied screwdriver.
Page 35
6 Lens mount (special mount) Pin assignment of the DC IN/VIDEO connector Usable lenses are as follows: Usable lenses (not supplied) • VCL-12S12XM special mount lens (f=12mm) • VCL-06S12XM special mount lens (f=6mm) 11 12 • VCL-03S12XM special mount lens (f=3.5mm) •...
Page 36
Location and Function of Parts Standard Connections Precautions (a Sony standard power supply/junction box and a standard cable) When you don’t connect XC-777A / 777AP *standard power supply: DC-77RR/77RRCE, DC-777/777CE as the above standard connections, be sure to *standard cable:...
Installation Usable Lenses You can use the following lenses with the camera. C-mount lens By using the LO-999CMT C-mount lens adaptor, you can mount any C-mount lens that does not project more than Usable lenses (not supplied) • VCL-12S12XM special mount lens (f=12mm) 4.1 mm.
Installation Attaching the Lens Screw the lens. Screw the C-mount adaptor into the lens mount of the camera. (only when using a C-mount lens). Connect the plug to the lens connector. (only when using an auto iris lens) Make this connection after replacing the lens cable plug with the PC-XC03 auto iris lens plug (not supplied).
PC-XC03 Auto Iris Lens Plug (not supplied) Remove the plug from the lens cable. Place the heat shrinkable tube over the lens cable. Pin 1; Video signal Solder the shielded wire onto the inside of the shell as illustrated. Pin 2; Ground Pin 3;...
Page 40
Installation Fit the plastic cover over the shell. Cover Notes • When handling or soldering, handle the plug with care. • When soldering the wires to the plug pins, solder them with a soldering iron temperature of less than 280°C (540°F). Shell Perform the soldering quickly within three seconds.
Installing the Camera on a Tripod When mounting the camera on a tripod, use the supplied tripod adaptor. Assemble the tripod adaptor parts. Mount the video camera You can install the video camera module on the tripod module on the tripod adaptor in any adaptor.
Never pull the cord itself. adaptor. • Connect the power cord after completing all other connections. Connecting the Camera to the JB-77 Junction Box Video chrominance Video signal signal output output (VBS/Y) (–/C) JB-77 CCXC-12P05 XC-777A/777AP S/D/R/U/L cable power supplier to DC IN/VIDEO connector...
Connect the DC-777/777CE camera adaptor to the power Note and supply and camera module as illustrated below. Make sure to read the operating instructions for the DC- 777/777CE camera adaptor. to DC IN/VIDEO connector XC-777A/777AP CCXC-12P05 S/D/R/U/L cable CAMERA connector (12-pin) DC-777/777CE...
Connect the DC-77RR/77RRCE camera adaptor to the Note power and supply and camera module as illustrated Make sure to read the operating instructions for the DC- below. 77RR/77RRCE camera adaptor. DC-77RR/77RRCE (Front panel) XC-777A/777AP CCXC-12P05S/D/R/U/L to DC IN/VIDEO camera connector connector Rear panel of the...
Specifications Pickup device Video signal to noise ratio Pickup device Interline transfer 1/3-inch CCD XC-777A: more than 48 dB Color filter Complementary color mosaic AGC: OFF (0 dB) Total picture elements XC-777AP: more than 46 dB XC-777A: 768(H) × 494(V) AGC: OFF (0 dB) XC-777AP: 752(H) ×...
Page 46
Specifications Storage humidity 20 to 90% (no condensation 12-pin camera cable permissible) CCXC-12P05S/D/R/U/L Shock resistance Less than 70G Auto iris lens plug 22 × 22 × 89 (mm) (w/h/d) Dimensions PC-XC03 × × 3 inches) Mass 75g (4 oz) Note This appliance conforms with EEC directive 87/308/EEC Accessories supplied regarding interference suppression.
You can build a high-performance system by using the LO-999ERK extension ring kit following XC-777A/777AP accessories. Extension ring kit designed for the XC-777A/777AP color video camera module. The operating instructions for the XCM-777A explains how to install and operate these accessories.
CCD Characteristics The following conditions that may be observed during the use of a CCD video camera are not associated with any fault of the camera. Smearing The picture may be smeared when a very bright object is shot. Pale stripe (smear) Videomonitor Very bright...