16
Device Description
The 10/100BASE-TX ports support network speeds of either 10 Mbps or
100 Mbps, and can operate in half- and full-duplex transfer modes. The ports also
offer automatic MDI/MDI-X crossover detection that gives true "plug and play"
capability – just plug the network cables into the ports and the ports will adjust
according to the end-node devices. The following are the recommended cables for
the RJ-45 connectors:
•
100 m – Cat 5 or better
Pos: 6.9 /Serie 852 (Ethernet-Zubehör)/Gerätebeschreibung/Spannungsversorgung 852-111 @ 4\mod_1236856130109_21.doc @ 28291
3.2.2
Power Input (PWR)
The female connector can easily be connected to the 3-pole male connector
located on the top of the switch.
The male connector shows the following pin assignment:
Table 3: Power Input (PWR)
Figure 4: Power input
Warning of damage to equipment by electrostatic discharge
DC Powered Industrial Eco Switch: Power is supplied through an external DC
power source. Check the technical specification section for information about the
DC power input voltage. Since the Industrial Eco Switch does not include a power
switch, plugging its power adapter into a power outlet will immediately power it
on.
Pos: 6.10 /Alle Serien (Allgemeine Module)/Überschriften für alle Serien/Anzeigeelemente - Überschrift 2 @ 4\mod_1240984390875_21.doc @ 31964
3.3
Display Elements
Pos: 6.11 /Serie 852 (Ethernet-Zubehör)/Gerätebeschreibung/LED-Anzeigen 852-111 @ 4\mod_1236854835984_21.doc @ 28273
This Industrial Switch is equipped with Unit LEDs to enable you to quickly
determine the status of the Switch, as well as Port LEDs to see what is happening
across your connection.
They are as follows:
Name
+
PWR
-
PWR
GND
NOTICE
WAGO-ETHERNET-Accessories 852
852-111 5 Port 100BASE-TX Industrial Eco Switch
Designation
Primary DC input
Primary DC input
Ground
Manual
Version 1.0.0