hit counter script
Download Print this page
Sealey AK714.V2-01 Instructions

Sealey AK714.V2-01 Instructions

Blind bearing puller set - 5pc

Advertisement

Quick Links

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1.
SAFETY
 WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are
adhered to when using this product.
DO NOT use this product if damaged.
Maintain product in good and clean condition for best and safest performance.
If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and chocks.
Wear approved eye protection. A full range of personal safety equ
Wear suitable clothing to avoid snagging. Do not wear loose jewellery and tie back long hair.
Account for all tools and parts being used.
If working off the vehicle, secure the work piece in a vice or clamp it to a work bench.
 DO NOT operate puller if you are tired or under the influence of alcohol, drugs or intoxicating medication.
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to
establish the current procedure and data. These instructions are provided as a guide only.
2.
INTRODUCTION
2.1.
Introduction
Fully chromed carbon steel medium stroke slide hammer. 370mm Overall length with 1.4kg hammer. Bearing
extractor collets with internal capacity from 11 to 32mm. Supplied in carry-case.
3.
CONTENTS
26mm - 32mm Attachment (Part No: AK714.V2-01)
20mm - 25mm Attachment (Part No: AK714.V2-02)
Slide hammer
15mm - 20mm Attachment (Part No: AK714.V2-04)
11mm - 15mm Attachment (Part No: AK714.V2-05)
(Part No: AK714.V2-03)
INSTRUCTIONS FOR:
BLIND BEARING PULLER SET - 5PC
ipment is available from your
dealer.

Advertisement

loading

Summary of Contents for Sealey AK714.V2-01

  • Page 1 Fully chromed carbon steel medium stroke slide hammer. 370mm Overall length with 1.4kg hammer. Bearing extractor collets with internal capacity from 11 to 32mm. Supplied in carry-case. CONTENTS 26mm - 32mm Attachment (Part No: AK714.V2-01) 20mm - 25mm Attachment (Part No: AK714.V2-02) Slide hammer (Part No: AK714.V2-03)
  • Page 2 INSTRUCTIONS 4.1. Prior to use of the required Loosen Grease attachment, disassemble and grease as shown in fig.1. Reassemble the attachment. 4.2. Screw the attachment into the Fig.1 Attachment Head shaft, as shown in fig.2. Tighten the attachment using a wrench. Note: Do not over tighten.

This manual is also suitable for:

Ak714.v2-02Ak714.v2-03Ak714.v2-04Ak714.v2-05