Advertisement
Quick Links
Seat Kit
Greensmaster
Model No. 04718
Model No. 04719
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Preparing the Machine
No Parts Required
Procedure
•
If you are installing this kit on a new diesel traction
unit without a seat, remove the 4 carriage bolts
and 4 nuts securing the shipping bracket to the
seat pan and armrest
shipping bracket and seat pan fasteners. Save the
armrest fasteners and spacer.
Important:
Ensure that you support the
armrest after removing it so that it does not
crimp or hang by the cables and wires.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3300/3400 Series TriFlex
Description
No parts required
Seat assembly
Flange nut
Short wire harness
(Figure
1). Discard the
Register at www.Toro.com.
®
Traction Unit
Qty.
–
Prepare the machine.
1
4
Install the new seat.
1
Figure 1
1. Armrest
2. Spacer
3. Shipping bracket (discard)
Original Instructions (EN)
All Rights Reserved *3433-172* A
Printed in the USA
Form No. 3433-172 Rev A
Installation Instructions
Use
4. Carriage bolt (save)
5. Carriage bolt (discard)
6. Seat pan
g033261
Advertisement
Related Manuals for Toro 04718
Summary of Contents for Toro 04718
- Page 1 Form No. 3433-172 Rev A Seat Kit Greensmaster ® 3300/3400 Series TriFlex ® Traction Unit Model No. 04718 Model No. 04719 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty.
- Page 2 • If you are installing a premium seat on a traction unit with a standard seat installed, complete the following procedure: Park the machine on level ground, shut off the engine, engage the parking brake, and remove the ignition key. Remove the 2 carriage bolts and nuts securing the armrest to the seat (Figure...
- Page 3 Installing the New Seat Parts needed for this procedure: Seat assembly Flange nut Short wire harness Procedure Install the 4 studs on the seat rails into the seat pan and secure them using 4 flange nuts (Figure g195601 Note: There are 2 installation locations in the seat pan.
- Page 4 Install the armrest to the seat using the 2 carriage bolts and flange nuts that you removed previously (Figure Note: If you have a diesel machine, install the spacer removed in 1 Preparing the Machine (page g015301 Figure 6 (Premium seat harness shown) 1.
-
Page 5: Operation
Operation Seat Controls Seat-Adjusting Lever The seat-adjusting lever is located on the front, left corner of the seat (Figure 7). Twisting the handle up allows you to adjust the seat forward and rearward. g195599 Figure 8 1. Seat (standard seat 3. - Page 6 Weight-Adjustment Lever Model 04719 Only You can adjust the seat for your weight to provide a smooth and comfortable ride. Important: To adjust the seat, the driver must be seated. Adjust the seat for your weight by pulling out the lever and then pumping it up to increase the suspension or down to decrease it (Figure...
- Page 7 Lumbar Support Knob Backrest Locking Lever Model 04719 Only Model 04719 Only The lumbar support increases both the seating comfort You can adjust the back of the seat to provide a more and a customized lumbar support for your lower back. comfortable ride.