Table of Contents
Advertisement
Rebooting the Access Point
Figure 3-19
1
Do not access the reset button in a Hazardous Location.
Caution
Rebooting the Access Point
To reboot (power cycle) the access point, follow these steps:
Use a Phillips screwdriver to remove the reset button screw
Step 1
screw.
Use a straightened paperclip, and push the reset button for less than 10 seconds. This action causes the
Step 2
access point to reboot (power cycle), all LEDs to turn off for approximately 5 seconds, and then the
LEDs to reactivate.
Replace the reset button screw and use a Phillips screwdriver to tighten to 22 to 24 in. lbs
Step 3
(2.49 to 2.71 Nm).
Cisco Aironet 1552 Series for Hazardous Locations Installation Guide
3-70
Reset Button Location - Models AIR-CAP1552SA/SD-x-K9 and AIR-CAP1552H-x-K9
4
Reset button
Chapter 3
Installing the 1552 Series Access Points in Hazardous Locations
5
(Figure
1
6
3-19). Be careful not to lose the
Advertisement
Table of Contents
