Related Manuals for Cisco CP-8851
Summary of Contents for Cisco CP-8851
- Page 1 CP-8851 / CP-8861 Do Not Ship Enclosure with Phone Installed [PHONE MUST BE INSTALLED ON-SITE]...
- Page 2 CP-8851 / 9961 Mounting the Enclosure Take into consideration before you install: - Due to the size and mass of this product, it is important that the Backbox is safely installed according to these installation instructions. - Make sure that the type of wall is capable of supporting the system and use screws that are suitable for that type of wall.
-
Page 3: Accessory Kits
Accessory Kits #6-32 x 3/16” Button Head Torx Smaller Drilled Spanner Dirver Bit Machine Screw Hex L-Key (Spare) for Acrylic Bezel Replacement Coverplate #8 Hex Nut Jumper Shunt (GND Lug) Mounting #6-32x5/8"Flat Head Screw Pin Torx Machine Screw (Spare - 2 Pieces) Keypad Cover Accessory Kit Torx Sec. - Page 4 Install all Cables then the Mounting Bracket Remove Handset & Disconnect Cord from Phone. Then Connect Power Plug (1) & Network Cable (2), etc. before Install Mounting Bracket Cisco CP-8851 / Cisco CP-8861 Mounting Screw (2 Pieces) Remove Both USB & KEM...
-
Page 5: Plug In The Usb Cable
Plug in the USB Cable USB Port USB-B Plug in to USB to Analog Audio Module (See Sheet 6 of 10) Cable Right Angle USB-A Plug... - Page 6 Mount the Backbox Assembly to the Wall Figure Shown Typical Installation: Tools Required: 1) Electric Powered Hand Drill 2) Drill Bit (Use Correct Drill Bit for Wood / Concrete) 3) Leveler 4) Torque Wrench, Wrench and Socket Step 3 A) Prepare Hole on Drywall (with Stud Behind) / Concrete B) Insert Stud Anchors in to Holes C) Align Backbox Assembly Mounting Holes to Studs D) Tighten Washers and Nuts that included with Stud Anchors...
- Page 7 Hookswitch Cradle to Handset Connections Use Provided #00 Screw Driver to Install Wires to Terminal Block Hookswitch Cradle Armored Cord USB to Analog Handset Lanyard Audio Module Black Wire to Terminal 4 Terminal Green Wire to Terminal 3 Block Yellow Wire to Terminal 2 Red Wire to Termianl 1 Black Wire USB-B...
- Page 8 Install Shunt on JP2 to Enable Auto Answer Mode Shunt...
- Page 9 Phone with Phone Mount Backbox Assembly Intall Phone with Phone Mount to Backbox...
- Page 10 Use Provided Security Torx Driver Bit to Fasten Screws to Backbox Tool Required: Electric Hand Drill or Powered Screwdriver Torx Screw (11x) Backbox Faceplate Assembly Assembly...
-
Page 11: Dimensions And Features
Dimensions and Features Security Torx Screw (Included Two Spare & Torx Driver Bit) Hookswitch Coverplate Available for Handsfree Operation, P/N: 611535A 2.874 [73.0] Ø0.512 [Ø13.0] (2 Places) Customer Replaceable Scratch Resistance Acrylic P/N: 621028A 4.724 [120.0] Customer Replaceable Customer Replaceable Armored Cord Handset with 304 Stainless Steel Faceplate Steel Lanyard...