Table of Contents
Advertisement
Operating a Cable Box or Satellite Receiver (SAT)
Setting the Manufacturer's
Code
You can program the supplied remote control
to operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer's code number (see the
following chart), then press ENTER.
For example, to operate a Sony satellite
receiver:
FUNCTION
CODE SET
SAT/CABLE
8
0
Manufacturer code numbers
(cable box)
Manufacturer
Hamlin/Regal
222, 223, 224, 225, 226
Jerrold/G. I.
201, 202, 203, 204, 205,
222, 206, 207, 208, 218
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Manufacturer code numbers
(satellite receiver)
Manufacturer
Sony
Geneal Electric
Hitachi
Hughes
Panasonic
RCA/PROSCAN
Toshiba
To operate the cable box or
satellite receiver (SAT)
ENTER
1
1
Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
satellite receiver.
2
Press SAT/CABLE (FUNCTION).
3
For other operations, refer to the
operating instructions that come with the
Code
equipment.
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
227, 228, 229
receiver.
219, 220, 221
214, 215
If the remote control doesn't work
209, 210, 211
216, 217
• Try repeating the set up procedures using
212, 213
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
Code number
projection TV.
801 (preset code for
remote control)
802, 808
805
Tips z
804
803
• If more than one code number is listed, try entering
802
them one by one until you come to the correct code for
806, 807
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
57
Advertisement
Table of Contents
