Advertisement
Quick Links
How to use Saw Guide Mini #4
Wide board
⑨Parallel sliding holder
⑥Screws
①Guide base
②Guide plate
Detach Positioning holder and fix
Mark the position where you want
Parallel sliding holder by a screw.
to cut.
Replace Dummy plate with Z-Saw UNIVERSAL
S-175, then start sawing by moving the guide
backward.
Saw Guide Mini optional parts
Saw guide gauge
This is a protractor for checking angles or marking.
Okada Hardware Mfg.Co.,Ltd.
561 Omura, Miki-shi, Hyogo, Japan 673-0404
TEL: 81-794-83-1111 / FAX: 81-794-83-5111
URL: http://www.z-saw.co.uk E-mail: sales@z-saw.co.uk
Slide bar
Prepare a straight edge or a straight
wooden piece to be used as Slide bar.
Clamp
⑨Parallel sliding
holder
⑩Dummy plate
Insert Dummy plate into the gap between
Guide base and Guide plate, and adjust
the position of the Guide and Slide bar to
the mark of the lumber. Fix Slide bar to the
board with clamps.
Fix the angle with the center screw.
ＭＥ２００４１２０Ａ
Instruction Sheet
Before using Saw Guide Mini
Contents and parts name
①Guide base
（aluminum）
⑤Positioning holder
（aluminum）
for cutting square lumber
⑥Screws
（Size: M4）
⑦４５° angle attachment
（aluminum）
Refer to "How to use Saw Guide Mini #2"
⑨Parallel sliding holder
（aluminum）
Refer to "How to use Saw Guide Mini #4"
⑧Screws
（Size: M4）
PISTOL S-117 Green
Applications : Cross, Rip and Slant-cut, general wood, hardwood, composite wood, plywood
Specifications : Blade thickness: 0.5mm, tooth pitch 1.40mm, kerf 0.66mm, Blade Length 180mm
Thank you for your purchase of Saw Guide Mini.
Please read this instruction carefully and keep it in good condition.
Caution :
Do not drop the guide and the saw as damage to them may occur.
Do not over tighten screws, as it may cause damage to screws, nuts or the guide.
Saw Guide Mini can not be used with double saws or saws which has the blade thicker than 0.5mm.
Always use Saw Guide Mini with Z-Saw UNIVERSAL S-175 or its spare blades.
Do mot use this product for a purpose for which it was not intended.
Notice :
Specifications may change without notice to improve quality.
Copyright 2003 Okada Hardware Manufacturing Company Limited. All rights reserved.
③Spacing plate
（0.53mm thick）
⑥Screws
（Size: M4）
④Nut plate for Guide plate
②Guide plate
⑩Dummy plate
Refer to "How to use Saw Guide Mini #3,#4"
Z-Saw UNIVERSAL S-175
(is designed to be used with Saw Guide Mini)
１８０ｍｍ
Advertisement
Related Manuals for Z-Saw Saw guide Mini
Summary of Contents for Z-Saw Saw guide Mini
- Page 1 Do not over tighten screws, as it may cause damage to screws, nuts or the guide. Saw Guide Mini can not be used with double saws or saws which has the blade thicker than 0.5mm. Always use Saw Guide Mini with Z-Saw UNIVERSAL S-175 or its spare blades.
- Page 2 How to change blades How to use Saw Guide Mini #2 ４５° cut Caution : Blade edges are very sharp and always wear gloves or swathe blade with towel. ②Guide plate How to attach blade Loosen screws to slide off the Guide plate.