Power Adapter; Ip Address; Factory Settings; Registering Device - Cisco 7821 User Manual
Hide thumbs
Also See for 7821:
- Quick start manual ,
- Administration manual (218 pages) ,
- User manual (94 pages)
Table of Contents
Advertisement
network as well as how to apply factory settings.
The following topics are covered:
- Power adapter
- Factory Settings
Power Adapter
1. Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the device and connect the other
end of the power adapter into an electrical power outlet.
Connect the ethernet cable between the Internet port on the device and the network port on a
router or switch to access LAN.
IP Address
1. Find out your Cisco 7821 IP Address
For Cisco 7821, press settings button then type 62 to check ip address of the phone.
Factory Settings
1. Reset to factory settings
This step is not required for out-of-the-box devices, however, if the device has been already used
then it is a must.
For Cisco 7821, press settings button then type 55. Confirm with OK on prompt to factory
reset the phone.
Wait sometime prior for device to reboot.
NOTE:
Do not unplug or remove power to the device while it is updating firmware and
configurations.
Registering Device
This chapter describes how to identify Cisco 7821 phone model, requirements that must be met
and how to register the device using manual configuration or auto provisioning.
The following topics are covered:
- Manual Configuration
- Auto Provisioning
Manual Configuration
This chapter describes how to set UAD settings, create PBXware extension and register the
- Quick Links:
- Installation
- Manual Configuration
Hide quick links:
Advertisement
Table of Contents
