Table of Contents
Advertisement
14. COMPRESSOR PREHEATING
When the outdoor heat exchanger temperature is lower than Operation temperature (Refer to Table 10)
and the heating operation has been stopped for 3 hours, power is applied to the compressor and
the compressor is heated.
(By heating the compressor, warm air is quickly discharged when operation is started.)
When operation was started, and when the outdoor temperature rises to Release temperature or greater,
preheating is over.
(Table 10 : Preheating Operation / Release Temperature)
Before 24 hour
Operation
Release
temperature
temperature
3°C
15. POWERFUL OPERATION
The POWERFUL OPERATION functions by pressing POWERFUL button on the remote controller.
The indoor unit & outdoor unit will operate at maximum power as shown in Table11.
(Table11)
COMPRESSOR FREQUENCY
FAN CONT. MODE
SETTING LOUVER
Release Condition is as follows.
[Cooling / Dry]
- Room tenperature < Setting temperature - 1.5°C or Operation time has passed 20 minutes.
[Heating]
- Room tenperature > Setting temperature +1.5°C or Operation time has passed 20 minutes.
16. 10°C HEAT OPERATION
10°C HEAT operation performs as below when pressing 10°C HEAT button or
Weekly timer setting on the remote controller.
(Table 12 : 10°C HEAT operation )
Mode
Setting temperature
Fan mode
LED display
Defrost operation
17. ECONOMY OPERATION
The ECONOMY operation functions by pressing ECONOMY button on the remote controller.
At the maximum output, ECONOMY Operation is approximately 70% of normal air conditioner operation
for cooling and heating.
The ECONOMY operation is almost the same operation as below settings.
(Table 13 )
Mode
Target temperature
After 24 hour
Operation
temperature
7°C
0°C
Powerful operation
Maximum
Powerful
Cooling/ Dry : 3, Heating : 5
=
=
Heating
10°C
Auto
Economy
Operate as normal
Cooling/ Dry
Setting temp.+1°C
Release
temperature
4°C
Heating
Setting temp.-1°C
01-24
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
