Table of Contents
Advertisement
2. Remove the dipstick and check the oil level
(Figure 7). If the oil level is below the Add mark on
the dipstick, slowly pour oil into the oil fill tube to
raise the oil level to the Full mark on the dipstick.
Do not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE
30 detergent oil with an API service classification of
SF, SG, SH, SJ, SL, or higher.)
Note: If you overfill the engine, pour some oil out
of it as directed in Changing the Engine Oil.
3. Install the dipstick.
Adjusting the Cutting Height
WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note: To raise the mower, move all the cutting height
levers forward; to lower the mower, move the all the
cutting height levers rearward (Figure 8).
Figure 7
1. Raise the mower
Note: The cutting height settings are 1 inch (25 mm);
1-1/2 inch (38 mm); 2 inches (51 mm); 2-1/2 inches
(64 mm); 3 inches (76 mm); 3-1/2 inches (89 mm); and
4 inches (102 mm).
Starting the Engine
1. Hold the blade control bar (Figure 9) against the
handle.
1. Blade control bar
2. Turn the ignition key (Figure 10) or pull recoil start
handle (Figure 11).
7
Figure 8
2. Lower the mower
Figure 9
- Quick Links:
- Charging the Battery
Hide quick links:
Advertisement
Table of Contents
