Page 1
E Model HCD-VX5A/VX7A Tourist Model HCD-VX5AJ QQ :376315150 2007.05.23 手机:13942296513 HCD-VX5A/VX5AJ/VX7A is the Amplifier, Video CD player, Tape Deck and Tuner Photo: HCD-VX7A section in MHC-VX5A/VX5AJ/VX7A. Dolby noise reduction manufactured under license Model Name Using Similar Mechanism HCD-GRX50/RXD7 from Dolby Laboratories Licensing Corporation.
LINE WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB- LISHED BY SONY.
Page 4
http://www.xiaoyu163.com 3 7 63 1515 0 MODEL IDENTIFICATION – Rear Panel – PART No. 无奇不有电路图网店整理 MODEL PART No. L 13942296513 VX5A : Saudi Arabia model 4-215-639-0π www.xiaoyu163.com VX5A : Malaysia and Singapore models 4-215-639-1π VX5A : Taiwan model 4-215-639-2π VX5A : E model 4-215-639-3π...
Page 5
http://www.xiaoyu163.com 3 7 63 1515 0 HOW TO OPEN THE DISC TRAY WHEN POWER SWITCH TURNS’ OFF. 1 Remove the Case. 3 Pull-out the disc tray. 2 Turn the cam to the direction of arrow. 无奇不有电路图网店整理 L 13942296513 www.xiaoyu163.com NOTE FOR INSTALLATION (ROTARY ENCODER) Note:When attaching the Base unit, Insert the BU cam section A into the groove of BU cam.
Page 8
http://www.xiaoyu163.com 3 7 63 1515 0 – Rear View – 1 S VIDEO jack 2 SYSTEM SELECT switch 3 VIDEO OUT jack 4 CD DIGITAL OUT, OPTICAL connector 5 VIDEO (AUDIO) IN jack 6 MD IN jack 7 MD OUT jack 8 SUPER WOOFER jack 9 FM ANTENNA terminals 0 AM ANTENNA terminals...
Page 9
http://www.xiaoyu163.com This section is extracted from instruction manual. 3 7 63 1515 0 无奇不有电路图网店整理 L 13942296513 www.xiaoyu163.com u163 – 9 – http://www.xiaoyu163.com...
http://www.xiaoyu163.com SECTION 4 TEST MODE 3 7 63 1515 0 [MC Cold Reset] [CD Delivery Mode] • The cold reset clears all data including preset data stored in the • This mode moves the optical pick-up to the position durable to RAM to initial conditions.
Page 14
http://www.xiaoyu163.com 3 7 63 1515 0 [Aging Mode] 2. Tape Deck Section This mode can be used for operation check of tape deck section. • The sequence during the aging mode is following as below. Tape deck section work in parallel. •...
Page 15
http://www.xiaoyu163.com 3 7 63 1515 0 [VIDEO CD Color-bars Mode] On this mode, the data of the color-bars signal as a picture signal and the 1 kHz sine wave signal as a sound signal are output by the mechanism controller (IC502) for the video CD signal check. When measurement of the voltage and waveform on the VIDEO board, perform it in this mode.
http://www.xiaoyu163.com SECTION 5 SECTION 6 MECHANICAL ADJUSTMENTS ELECTRICAL ADJUSTMENTS 3 7 63 1515 0 Precaution DECK SECTION 0 dB = 0.775 V 1. Clean the following parts with a denatured alcohol-moistened swab: 1. Demagnetize the record/playback head with a head demagne- record/playback heads pinch rollers tizer.
Page 17
http://www.xiaoyu163.com 3 7 63 1515 0 DECK B 2. Turn the adjustment screw and check output peaks. If the peaks Tape Speed Adjustment do not match for L-CH and R-CH, turn the adjustment screw Mode: Playback so that outputs match within 1dB of peak. test tape WS-48B frequency counter...
Page 18
http://www.xiaoyu163.com 3 7 63 1515 0 Specification values: DECK B REC Bias Adjustment J101 PB level: 47.2 to 53.0 mV (– 24.3 to – 23.3 dB) Procedure: 1. Mode: Record Adjustment Location: MAIN board FUNCTION: VIDEO MAIN board – MAIN BOARD (Conductor Side) – VIDEO (AUDIO) IN jack (J101) L-CH, R-CH RV301...
http://www.xiaoyu163.com 3 7 6 3 1 5 1 5 0 E-F Balance (1 Track Jump) Check CD SECTION VIDEO SECTION oscilloscope Note: Frequency Adjustment 1. CD Block is basically designed to operate without adjustment. There- Connection: BD board fore, check each item in order given. 2.
http://www.xiaoyu163.com 3 7 6 3 1 5 1 5 0 7-6. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS • Circuit Boards Location VIDEO board Note on Printed Wiring Board: Note on Schematic Diagram: TRANS board • X : parts extracted from the component side. •...
Page 49
http://www.xiaoyu163.com 3 7 63 1515 0 IC103 CXA2568M-T6 HOLD APC PD AMP LC/PD APC LD AMP – LD ON – – – HOLD SW AGC CONT AGC VTH 50µA RF BOT – – – – RFTC RF SUMMING AMP RF EQ AMP RF I RF O –...
Page 50
http://www.xiaoyu163.com 3 7 63 1515 0 – VIDEO Board – IC509 PCM1727E-2/T2 384fs CLOCK MANAGER • DUAL PLL DGND PGND POWER SUPPLY SCKO1 SCKO2 NCKO LRCK SCKO3 AUDIO DATA INPUT DATA INTERFACE MODE CONTROL RSTB ZERO OPEN 8 TIME OVER SAMPLING DIGITAL FILTER •...
http://www.xiaoyu163.com 3 7 63 1515 0 7-31. IC PIN FUNCTION DESCRIPTION • MAIN BOARD IC501 M30622MA-A09FP (SYSTEM CONTROLLER) Pin No. Pin Name Description STK-MUTE Power amplifier on/off selection signal output terminal “L”: standby mode, “H”: on Power on/off control signal output for the audio system (+5V) and deck, panel, audio system POWER (+7V) “L”: standby mode, “H”: power on F-RELAY...
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description VC L+R/L–R Virtual cinema L+R/L–R selection signal output to the LV1150 (IC1201) VC BYPASS Virtual cinema bypass control signal output terminal Not used (open) Filament on/off selection signal output for the fluorescent indicator tube FL SW “L”: on, “H”: off Not used in this set...
Page 54
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description High/normal speed selection signal output of the capstan motor (M1) CAP-M-H/L “L”: normal speed, “H”: high speed Whether a music is present or not from HA12215F (IC301) is detected at automatic music sensor AMS-IN “L”: music is present, “H”: music is not present Line muting on/off selection signal output to the HA12215F (IC301)
Page 55
http://www.xiaoyu163.com 3 7 63 1515 0 • VIDEO BOARD IC502 M30620MC-A05FP (CD MECHANISM CONTROLLER) Pin No. Pin Name Description SENSE Internal status (SENSE) signal input from the CXD3008Q (IC101) SENSE CLK Sense serial data reading clock signal output to the CXD3008Q (IC101) DSP DATA Serial data output to the CXD3008Q (IC101) DSP LATCH...
Page 56
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description 42, 43 Not used (open) SHIMUKE Destination setting terminal “L”: Chinese, “H”: English (fixed at “H” in this set) Vertical synchronized signal input from the MPEG video/audio decoder (IC505) “L” active BUS XWRL Not used (open) LO.BOOST...
Page 57
http://www.xiaoyu163.com 3 7 63 1515 0 • VIDEO BOARD IC505 CL680T-D1 (MPEG VIDEO/AUDIO DECODER, VIDEO SIGNAL PROCESSOR) Pin No. Pin Name Description Not used (open) — Ground terminal CD-BCK CD decode bit clock signal (2.8224 MHz) input from the CXD3008Q (IC101) CD-DATA CD decode data input from the CXD3008Q (IC101) CD-LRCK...
Page 58
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description RREF Fix the video signal output level control VREF Reference voltage (+1.235V) output terminal AVDD-DAC — Power supply terminal (+3.3V) (for D/A converter) C-OUT Chrominance video signal output terminal AGND-DAC —...
Page 59
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description VDD3 — Power supply terminal (+3.3V) HSEL Command selection signal input from the CD mechanism controller (IC502) CDG-SDATA Not used (fixed at “L”) CDG-VFSY Not used (fixed at “L”) CDG-S0S1 Not used (fixed at “L”) 125 to 128...
Page 60
http://www.xiaoyu163.com 3 7 63 1515 0 • PANEL BOARD IC601 TMP88CS76F-6005 (FLUORESCENT INDICATOR TUBE DRIVER, KEY CONTROL) Pin No. Pin Name Description SIRCS Remote control signal input from the remote control receiver (IC602) JOG-A Jog dial pulse input from the rotary encoder (S601 JOG) (A phase input) LED SCK Serial data transfer clock signal output to the LED driver (IC604) LED LAT...
Page 61
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description — Power supply terminal (+5V) System clock input terminal (12.5 MHz) — Ground terminal XOUT System clock output terminal (12.5 MHz) System reset signal input from the reset signal generator (IC502) “L”: reset RESET For several hundreds msec.
Page 62
http://www.xiaoyu163.com SECTION 8 EXPLODED VIEWS 3 7 63 1515 0 NOTE: • Items marked “*” are not stocked since they • -XX and -X mean standardized parts, so they The components identified by mark ! or dotted line with mark may have some difference from the original are seldom required for routine service.
Page 64
http://www.xiaoyu163.com 3 7 63 1515 0 (3) CHASSIS SECTION CDM38L-5BD34L not supplied not supplied not supplied VX7A L 13942296513 M501 T951 E, IA, JE E, IA, TH, JE EA, MY, SP, TW not supplied EA, MY, SP, HK, TW u163 –...
Page 67
http://www.xiaoyu163.com 3 7 63 1515 0 (5) CD MECHANISM DECK SECITON-2 (CDM38L-5BD34L) supplied L 13942296513 M801 BU-5BD34L S811 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 4-981-789-11 BRACKET (2), YOKE * 262 1-658-578-11 MOTOR (SLIDE) BOARD 4-977-954-01 PULLEY (SL) 4-982-447-01 SPRING (BU), COMPRESSION 4-977-953-01 GEAR (SL-A)
Page 68
http://www.xiaoyu163.com 3 7 63 1515 0 (6) BASE UNIT SECTION (BU-5BD34L) L 13942296513 M101 M102 The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number specified. Ref. No. Part No. Description Remark Ref.
Page 69
http://www.xiaoyu163.com 3 7 63 1515 0 (7) TAPE MECHANISM DECK SECTION-1 (TCM-230AWR2) HP101 HRPE101 L 13942296513 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 3-376-464-11 SCREW (+PTT 2.6X6), GROUND POINT * 409 A-2007-731-A AUDIO BOARD, COMPLETE 3-036-914-01 RIVET 3-032-809-02 SPRING (L), TORSION 3-016-574-11 SPRING (HEAD), TENSION...
Page 70
http://www.xiaoyu163.com 3 7 63 1515 0 (8) TAPE MECHANISM DECK SECTION-2 (TCM-230AWR2) L 13942296513 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark * 451 X-3374-214-3 CHASSIS ASSY, MAIN A-2004-629-A MECHANICAL BLOCK ASSY 3-016-570-01 BELT (CAPSTAN) 3-016-566-01 SLIDER, REVERSE 3-016-569-01 BELT (TENSION) * 461 A-2007-732-A LEAF SW BOARD, COMPLETE...
Page 71
http://www.xiaoyu163.com SECTION 9 AUDIO 3 7 63 1515 0 ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark ! or dotted line with mark parts list may be different from the parts speci- are seldom required for routine service.