Related Manuals for Makita 4326
Summary of Contents for Makita 4326
- Page 1 INSTRUCTION MANUAL Jig Saw 4326 4327 4328 4329 008081 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
A-weighted noise level determined Do not dispose of electric equipment according to EN60745: together with household waste Model 4326,4327 material! observance European Sound pressure level (L ) : 86 dB (A) Directive, Waste Electric Sound power level (L ) : 97 dB (A) -
Page 3: General Power Tool Safety Warnings
Water entering a power tool will Jig Saw increase the risk of electric shock. Model No./ Type: 4326, 4327, 4328, 4329 Do not abuse the cord. Never use the cord for Conforms to the following European Directives: carrying, pulling or unplugging the power tool. -
Page 4: Jig Saw Safety Warnings
If operating a power tool in a damp location is 21. Store idle power tools out of the reach of unavoidable, use a residual current device children and do not allow persons unfamiliar (RCD) protected supply. Use of an RCD with the power tool or these instructions to reduces the risk of electric shock. -
Page 5: Functional Description
Make sure the blade is not contacting the FUNCTIONAL DESCRIPTION workpiece before the switch is turned on. Keep hands away from moving parts. 10. Do not leave the tool running. Operate the tool CAUTION: only when hand-held. Always be sure that the tool is switched off and •... - Page 6 CAUTION: ASSEMBLY Before plugging in the tool, always check to see • that the switch trigger actuates properly and CAUTION: returns to the "OFF" position when released. Always be sure that the tool is switched off and To start the tool, simply pull the switch trigger. Release •...
-
Page 7: Operation
Then rest the figure to keep it from being lost. base flat on the workpiece and gently move the tool forward along the previously marked cutting line. Adjusting roller (For models 4326/4327) 1. Cutting line 1. Blade 2. Base 2. -
Page 8: Metal Cutting
B) Plunge cutting 1. Hex wrench 2. Bolt 3. Base 008089 Tilt the base until the desired bevel angle is obtained. 008093 The edge of the motor housing indicates the bevel angle You need not bore a starting hole or make a lead- by graduations. - Page 9 Clean cutting operations performed 1. Bolt Aluminum base type connecting this tool to a Makita vacuum cleaner. Insert 2. Fence guide the hose of the vacuum cleaner into the hole at the rear 3. Hex wrench of the tool. Lower the dust cover before operation. 4.
-
Page 10: Cover Plate
Insert the circular guide pin through either of the Cover plate for aluminum base two holes on the fence guide. Screw the threaded (Optional accessory) knob onto the pin to secure the pin. Now slide the rip fence to the desired cutting 1. - Page 12 Makita Jan-Baptist Vinkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan www.makita.com 884727G224...