Table of Contents
Advertisement
Adjust the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the exhaust vent during Tilt Foot adjustment as
it can become heated while the projector is turned on and after it is
turned off.
2. Push up and hold the Adjustable Tilt Foot Lever on the front of
the projector to extend the adjustable tilt foot.
3. Lower the front of the projector to the desired height.
4. Release the Adjustable Tilt Foot Lever to lock the Adjustable tilt
foot.
The tilt foot can be extended up to 2 inches/52 mm.
There is approximately 10 degrees (up) of adjustment for the front of
the projector.
Rotate the rear foot to the desired height in order to square the image
on the projection surface.
CAUTION:
• Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
Adjusting the left and right tilt of an image [Rear foot]
• Rotate the rear foot.
The rear foot can be extended up to 1 inch/26.5 mm. Rotating the rear
foot allows the projector to be placed horizontally.
NOTE:
• Do not extend the rear foot beyond its height limit (0.8 inch/21.5 mm). Doing
so may cause the rear foot to come out of the projector.
• If extending the left rear foot (viewed from the rear) causes the protrusion to
interfere with the floor, extend the right rear foot by 0.5 inch/12 mm or longer.
If extending the right rear foot causes the protrusion to interfere with the floor,
extend the left rear foot by 0.3 inch/8 mm.
2. Projecting an Image (Basic Operation)
Up
19
1
Adjustable Tilt
Foot Lever
Adjustable Tilt Foot
3
Rear feet
Down
2
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
