PORTABLE AUDIO SYSTEM
RA-P31B/RA-P30W
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
INSTRUCTIONS
LVT1848-001B [J]
Warnings, Cautions and Others / Mises en garde, précautions et indications diverses
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure
your complete understanding and to obtain the best possible performance from the unit.
(For U.S.A)
For U.S.A
This equipment has been tested and found to comply
CAUTION
with the limits for a Class B digital device, pursuant
RISK OF ELECTRIC SHOCK
to part 15 of the FCC Rules. These limits are
DO NOT OPEN
designed to provide reasonable protection against
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
harmful interference in a residential installation.
DO NOT REMOVE COVER (OR BACK).
This equipment generates, uses and can radiate
NO USER SERVICEABLE PARTS INSIDE.
radio frequency energy and, if not installed and
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
used in accordance with the instructions, may cause
harmful interference to radio communications.
The lightning flash with arrowhead symbol,
However, there is no guarantee that interference will
within an equilateral triangle is intended to
not occur in a particular installation. If this equipment
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
does cause harmful interference to radio or television
enclosure
that
may
be
of
sufficient
reception, which can be determined by turning the
magnitude to constitute a risk of electric
shock to persons.
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
The exclamation point within an equilateral
following measures:
triangle is intended to alert the user to the
Reorient or relocate the receiving antenna.
presence of important operating and
maintenance (servicing) instructions in the
Increase the separation between the equipment and
literature accompanying the appliance.
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
ATTENTION
Consult the dealer or an experienced radio/TV
RISQUE D'ÉLECTROCUTION
NE PAS OUVRIR
technician for help.
ATTENTION: POUR É VITER TOUT RISQUE D' É LECTROCUTION,
CAUTION
NE PAS OUVRIR LE BOîTIER.
AUCUNE PIÈCE INT É RIEURE N'EST À R É GLER PAR L'UTILISATEUR.
Changes or modifications not approved by JVC
SE R É F É RER À UN AGENT QUALIFI É EN CAS DE PROBLÈME.
could void the user's authority to operate the
equipment.
Le symbole de I'éclair à I'intérieur d'un
triangle équilatéral est destiné à alerter
For Canada/pour le Canada
I'utilisateur sur la présence d'une "tension
dangereuse" non isolée dans le boîtier du
THIS DIGITAL APPARATUS DOES NOT
produit. Cette tension est suffisante pour
EXCEED THE CLASS B LIMITS FOR
provoquer I'électrocution de personnes.
RADIO NOISE EMISSIONS FROM DIGITAL
APPARATUS AS SET OUT IN THE
Le point d'exclamation à I'intérieur d'un
INTERFERENCE-CAUSING EQUIPMENT
triangle équilatéral est destiné à alerter
STANDARD ENTITLED "DIGITAL APPARATUS,"
I'utilisateur sur la présence d'opérations
ICES-003 OF THE DEPARTMENT OF
d'entretien importantes au sujet desquelles
des renseignements se trouvent dans le
COMMUNICATIONS.
manuel d'instructions.
CET APPAREIL NUMERIQUE RESPECTE LES
(For U.S.A)
LIMITES DE BRUITS RADIOELECTRIQUES
APPLICABLES AUX APPAREILS NUMIRIQUES
WARNING: TO REDUCE THE RISK OF FIRE
DE CLASSE B PRESCRITES DANS LA NORME
OR ELECTRIC SHOCK, DO NOT EXPOSE
SUR LE MATERIEL BROUILLEUR; "APPAREILS
THIS APPLIANCE TO RAIN OR MOISTURE.
NUMERIQUES", NMB-003 EDICTEE PAR LE
MINISTRE DES COMMUNICATIONS.
EN
©2008 Victor Company of Japan, Limited
0108NYMCREBET
Precautions
Rating label is placed on the exterior of the bottom.
• Install in a place which is level, dry and neither too hot
nor too cold–between 5°C and 35°C (41°F and 95°F).
• Install the System in a location with adequate
ventilation to prevent internal heat buildup inside
the System.
DO NOT install the System in a location
near heat sources, or in a place subject to
direct sunlight, excessive dust or vibration.
• Leave sufficient distance between the System and
the TV.
• Keep the speakers away from the TV to avoid
interference with TV.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1. Front: No obstructions and open spacing.
2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand
with a height of 10 cm (3-
15
/
) or more.
"
16
Attention: Aération correcte
Pour prévenir tout risque de décharge électrique ou d'incendie et éviter toute détérioration, installez
l'appareil de la manière suivante:
1. Avant: Bien dégagé de tout objet.
2. Côtés/dessus/dessous: Assurez-vous que rien ne bloque les espaces indiqués sur le schéma ci-dessous.
3. Dessous: Posez l'appareil sur une surface plane et horizontale. Veillez à ce que sa ventilation correcte
puisse se faire en le plaçant sur un support d'au moins dix centimètres de hauteur.
Front
Side
Face
Côté
Getting Started
Insulation sheet
Supplied Accessories
Prepare the Remote
Control
After unpacking, check to be sure
• When you use the remote
that you have all the following items.
control for the first time, pull
out the insulation sheet.
• Remote control
• AC adapter
(Front side)
• CR2025 (×2) lithium coin batteries
Replacing the Battery
One is loaded on the remote
in the Remote Control
control at the factory.
• Insert the battery into the
remote control by matching
the polarity (+ and –)
correctly.
(Rear side)
Warning
• Store the battery in a place where children cannot reach. If a child accidentally swallows the battery,
consult a doctor immediately.
• Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Doing any of these things
may cause the battery to give off heat, crack, or start a fire.
• Do not leave the battery with other metallic materials. Doing this may cause the battery to give off heat,
crack, or start a fire.
• When throwing away or saving the battery, wrap it in tape and insulate; otherwise, the battery may start to
give off heat, crack, or start a fire.
• Do not poke the battery with tweezers or similar tools. Doing this may cause the battery to give off heat,
crack, or start a fire.
• Dispose of battery in the proper manner, according to federal, state, and local regulations.
• The batteries (battery pack or batteries installed ) shall not be exposed to
excessive heat source such as sunshine, fire or the like.
For USA-California Only
This product contains a CR Coin Cell Lithium Battery which contains Perchlorate Material – special
handling amay apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
CAUTION:
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Basic and Common Operations
Press
Functions
• Light the display screen for 5 seconds when the power is
turned off.
• Temporarily stop the alarm sound when the alarm is ringing
(SNOOZE).
(see "To stop the alarm sound")
Press
Functions
• Switch on/off the SURROUND.
You can enjoy music with
spatial and deep sound in
this mode. (The mode is not
effective when the monaural is
selected.)
• While the clock or the alarm
time are set, return to the
previous item.
See "How to set the time and
See "How to set the
Remote control
use the alarm"
time and use the alarm"
sensor
Display Information
Current time/
alarm time
Date
Day of the week
Explanation of Icons
Off: current time / On: alarm time
Off: alarm off / On: alarm on / Blinking: alarm sounding (When "TIMER PLAY" is set)
Blinks while snoozing (the alarm is paused)
SLEEP Lighting when the sleep mode is selected.
Preparation of the Unit
Loading batteries for the Unit (The battery power supply)
Insert three batteries to each compartment (six batteries total). Be sure to match the poles (+/-) correctly.
While the AC adapter is connected to the wall outlet, the unit works without batteries.
R6 (SUM-3)/AA (15F) (not supplied)
Lithium
coin battery
(CR2025)
Open the battery compartment
cover by pressing the small tab.
Close the cover in the order shown by the numbers.
Loading batteries for the Clock
Be sure to match the poles (+/-) correctly.
Lithium coin battery
(CR2025) (supplied)
Plus terminal
Side of the battery
Plus terminal
Insert the battery with pushing the plus
Press the tab to open
the cover.
terminal up to be sure the terminal
contacts the side of the battery.
Time to change the battery
As the battery is running out, the display indication dims or the alarm may beep at the time the alarm
is not set at. Replace the battery in such cases.
Connecting the AC adapter
CAUTION:
To a wall outlet Plug
To avoid risk of fire, and to prevent damage.
the AC adapter only
• Do not use AC adapters except for the
after all connections
supplied AC adapter.
are completed.
• Do not use the supplied AC adapter for
other equipment.
AC adapter (supplied)
RA-P31B: AA-R9031 / RA-P30W: AA-R9028
Turn on or off the power
Adjust the volume
Press
Functions
Press
Turns on or off the power
Adjust the volume level from 00 to a
maximum of 20.
When the power is turned off at volume level "15"
–: Turn down the volume.
or higher, the unit automatically sets the volume
+: Turn up the volume.
level to "14" the next time it is turned on.
Connector plug
Press
• Switch on/off the backlight when the
button is held down.
FM MODE/
• Switch FM stereo/monaural when FM is
selected.
¢
(see "Playing back from iPod" and
4
"Listening to FM Broadcasts")
38
Select a source
Press
Select a source
iPod → FM → AUX
Sound source indicator
iPod/FM/AUX (blinks while muted)
When adjusting the volume
00 - 20
When FM radio is selected
P01 - P20 (channel) /
87.5 - 108.0 MHz (frequency)
When the source is set to iPod and the
iPod (slow blinking)
alarm is set to TIMER PLAY
When the source is set to FM radio and
87.5 - 108.0 MHz ↔ P01-P20
the alarm is set to TIMER PLAY
When battery power is low
- - -
When trying to set alarm to TIMER PLAY
while selecting AUX
SURROUND starts lighting when it is switched on.
"STEREO" is displayed when an FM stereo broadcast is received.
"MONO" is displayed when the monaural is selected. (see "Listening to FM Broadcasts ")
Current time: Blinking / Other Clock Display: Lighting
FM wire antenna
Close the cover in the order
shown by the numbers.
Functions
Functions
Functions