TABLE OF CONTENTS PRESENTATION…………………………………………………………………………………………. 4 NEW DOOR ON DOOR INSTALLATION SYSTEM………………………………………….... 7 CONTROL FUNCTIONS………………………………………………………………………………..8 COMBINED BICOMPRESSORS………………………………………………………………………… 8 2.1.1 START AND SWITCH-OFF OF THE APPLIANCE ……………………………………………..8 2.1.2 REGULATION OF THE FREEZER TEMPERATURE……………………………………....8 2.1.3 FAST-FREEZING FUNCTION ………………………………………………………………....9 2.1.4 TEMPERATURE ALARM………………………………………………………………………………. 9 2.1.5 REGULATION OF THE REFRIGERATOR TEMPERATURE……………………………………..
(apart from 1780 bicompressor) • control panel on the top of the appliance. The principal markets are: Germany, Austria, Holland, Belgium, Swisse, Great Britain. The principal trademarks are: AEG, JUNO, ELECTROLUX, PRIVILEG. 4/16...
Page 5
The Door on Door range presents both the electronic and mechanical control system version for every model, except for the bicompressor that it is available only in electronic version. The models are: BASE MODEL TYPE CAPACITY CONTROL [ litres ] 922 692 .
Page 6
Freezer Refrigerator Combined bicompressor 3/4 STAR 6/16...
1.1 New Door on Door Installation System The characteristics of the new Door on Door installation system are: • easy installing • fast installing • no measurement • applicability to every cabinet The installation operations are described in the user manual. 7/16...
2. Control Functions The combined bicompressor refrigerator is available only in the electronic version. 2.1 Combined Bicompressor Buttons Display T1= ON/OFF refrigerator L1= ON/OFF refrigerator D1= refrigerator T2= refrigerator temperature increase L2= coolmatic function D2= freezer T3= refrigerator temperature decrease L3= ON/OFF freezer T4= coolmatic function L4= frostmatic function...
2.1.3 Fast-freezing Function By pressing T8 button the fast-freezing function activates and it powers the compressor continuously for 54 hours. To deactivate the function earlier than 54 hours, just press T8 button again. The L4 led lights till the freezing function is activated. 2.1.4 Temperature Alarm The alarm is activated when the temperature reaches –8°C: L5 led and the display flash and the buzzer sounds.
2.1.9 Demo Mode By pressing at the same time the decrease temperature button and ON/OFF one for 5 seconds the demo function activates. The inside machine temperature must be above +10°C so that the function can activate. The display board is active, the light turns on when you open the door, but the compressor is switched off. 2.1.10 Open Door Alarm The open door alarm is activated through a sensor (reed-element) located on the display board which identifies the presence of a little magnet on the refrigerator door.
3. NTC Sensors Failure The NTC sensors have the following temperature-resistance characteristic: Abnormal resistance values will be interpreted as sensor failure and the display will show a signal. If a sensor is defective, the related compressor will be on for about 30 minutes and off for about 45 minutes.
Page 12
Conversion table for NTC sensors : 12/16...
4. Four Star Compartment Buttons T1= ON/OFF L1= ON/OFF T2= temperature increase L2= coolmatic function T3= temperature decrease L4= frostmatic function T4= coolmatic function T8= frostmatic function The description of the functions, buttons and leds is the same as the one of the combined bicompressors. The only difference is the fast-freezing function and the introduction of a balance heater with automatic connection.
5. Refrigeratore The description of the functions, buttons and leds is the same as the one of the combined bicompressors. 6. Freezer The description of the functions, buttons and leds is the same as the one of the combined bicompressors. 14/16...
7. SYMBOLS OF THE DISPLAY Refrigerator "0" – "39" steady light: Displays the average temperature in the refrigerator "2" – "8" flashing light: Displayed during temperature setting. Disappears 5 seconds after temperature setting is complete "0" steady light: Displayed if the temperature in the refrigerator is below 0°C "H"...