Cisco 7941G User Manual

Handset, headset, and speakerphone for cisco unified communications manager 9.0 (sccp and sip)

Hide thumbs Also See for 7941G:

Download this manual See also: Administration Manual, User Manual

Handset, Headset, and Speakerphone

•

Headset, Handset, and Speaker Overview

You can use your phone with these audio devices: a handset, headset, or speakerphone.

The phone is off-hook when the handset is lifted or another audio device is in use.

The phone is on-hook when the handset is in its cradle and other audio devices are not in use.

Handset

The following table describes how to use the handset.

If you want to...

Use the handset

Switch to the speakerphone or a

headset during a call

Adjust the volume level for a call

Headset, Handset, and Speaker Overview, page 1

Handset, page 1

Headset, page 2

Speakerphone, page 3

AutoAnswer with Headset or Speakerphone, page 3

Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified

Then...

Lift it to go off-hook; replace it to go on-hook.

The ringing line is automatically selected. Contact your system

administrator about options to always select the primary line.

Press

( ), then hang up the handset.

Press the Volume button during a call or after invoking a dial tone.

Press Save to preserve the volume level for future calls.

Communications Manager 9.0 (SCCP and SIP)

Page 1 Press the Volume button during a call or after invoking a dial tone. Press Save to preserve the volume level for future calls. Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
Page 2: Control Wired Headset Sidetone
Handset, Headset, and Speakerphone Headset Headset Your phone supports four- or six-wire headset jacks for wired headsets. Cisco Unified IP Phones 7962G and 7942G also support wireless headsets. For information about purchasing headsets, see Wired and Wireless Headsets. You can use a headset with all of the controls on your phone, including However, if you use a wireless headset, refer to the wireless headset documentation for instructions.
Page 3: Wireless Headset
AutoAnswer to use either the speakerphone or a headset. You may use AutoAnswer if you receive a high volume of incoming calls. Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
Page 4 Otherwise, calls ring normally and you must manually answer them. speakerphone AutoAnswer is disabled when the Do Not Disturb feature is active. Cisco Unified IP Phone 7941G, 7941G-GE, 7942, 7961G, 7961G-GE, and 7962 User Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)

7941g-ge 7942 7961g 7961g-ge 7962