Page 1
Operating and installation instructions Cooker hood DA 2900 DA 2900 EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
Caring for the environment Disposal of the packing material Disposal of your old appliance The packaging is designed to protect Electrical and electronic appliances the appliance from damage during often contain valuable materials. They transportation. The packaging materials also contain materials which, if handled used are selected from materials which or disposed of incorrectly, could be are environmentally friendly for...
Any other usage is not supported by This appliance complies with all the manufacturer and could be relevant safety requirements. dangerous. Miele cannot be held liable Improper use can, however, present for damage resulting from incorrect or a risk of both personal injury and improper use or operation.
Installation, maintenance and the appliance could be damaged. repairs may only be carried out by a Consult a qualified electrician if in any Miele authorised person in strict doubt. accordance with current national and The electrical safety of this local safety regulations.
Page 6
These models may only be combined Great care should be taken when with a Miele external motor. using the cooker hood at the same time and in the same room or area of the The appliance must not be used in a house as another heating appliance non-stationary location (e.g.
Page 7
Warning and Safety instructions This also applies to recirculation mode If the hood is being operated in if the air is being directed out of the recirculation mode and the air is being kitchen. directed back into the kitchen, the above restrictions do not apply.
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Do not use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
Page 11
Guide to the appliance Edge extraction panels Operating hours button The grease filter symbol l for the DRP 2900 Glass (4 panels) or DRP 2900 Stainless steel (4 panels) operating hours button lights up when the grease filters need to be cleaned. Hob lighting The charcoal filter symbol ...
Description of the functions . . . air recirculation: The cooker hood works with (DUU 2900 conversion kit for . . . air extraction: recirculation required) The cooker hood draws in the cooking The air is drawn in through the edge vapours.
1 to 3 are mediate vicinity, the remote control usually sufficient for normal cooking. coding can be altered. Please contact the Miele Service Intensive setting Department (see "After Sales Service"). For short periods of cooking food with intensive vapours and a strong aroma, e.g.
Operation Run-on option 5 ¢15 To switch the fan off K ^ Reduce the power level by pressing It is advisable to run the fan for a few minutes after cooking has finished to the – button on the remote control neutralise any lingering odours in the until the fan switches off, air, whether you are using air extraction...
Operation Power management Power management can be deactivated. This can only be done via The cooker hood features a power the control panel on the cooker hood. It management system for switching off cannot be deactivated using the remote the lighting and reducing the fan power control.
Operation Filter operating hours The grease filter operating hours counter [ counter is set at the factory for 30 hours. This can be lengthened or The number of hours the cooker hood shortened. You can choose 20, 30, 40 has been in operation is stored in or 50 hours.
Page 18
Operation Activating and altering the charcoal Checking the filter operating hours filter operating hours counter counter (recirculation mode with conversion kit To check the percentage of time set fitted) already used: ^ Switch the fan on with the On/Off The charcoal filter is needed for button K.
^ All external surfaces and controls can cleaning agents. These will damage be cleaned using a Miele E-Cloth or the surface material. with warm water and a little – sharp metal scrapers, washing-up liquid applied with a well wrung-out soft sponge or cloth.
Cleaning and care Panels and grease filters Important for appliances with glass surfaces The edge extraction panels and the re-usable metal grease filters in the Glass surfaces can be cleaned using a proprietary non-abrasive cleaning appliance remove solid particles agent designed specifically for use on (grease, dust, etc.) from the kitchen glass.
Page 21
Cleaning and care ^ The panels and grease filters need to To avoid damaging the filters, be removed for cleaning. panels or the hob below, make sure During cooking condensation forms you hold the filters and panels on the panels, which evaporates after securely at all times when handling cooking.
Page 22
Make sure that the spray arm can disengage the clip. move freely. ^ Select a programme with a maximum temperature of 65° C. If a Miele dishwasher is being used, select the Sensor wash programme. ^ Use a mild dishwasher detergent.
Cleaning and care ^ To replace a panel, hold it firmly with both hands, hook it over the retaining bar (see detail in the illustration), tilt the panel upwards and press it into the locking clip at the front until you hear it click into position.
Cleaning and care Fitting and replacing the When fitting for the first time: charcoal filters ^ Activate the operating hours counter (see "Operation"). If the cooker hood is connected for recirculation, two active charcoal filters Always replace the charcoal filters im- must be inserted in the separate mediately if recirculation unit.
Cleaning and care Remote control The surface should be wiped with a damp cloth only. Only use a damp cloth as water could get into the unit and cause damage. Replacing the battery The remote control uses one 3 V, CR 2032 battery.
Installation Appliance dimensions Please see the following pages for more details on the diagrams.
Page 27
Installation 4) If the cooker hood is being installed Before installation, it is important near to a wall, a minimum distance of at least 50 mm must be observed so that to read the information given on the following pages as well as the the edge extraction panels and the grease filters can be removed easily.
Installation Safety distance between hob and – However, we recommend a minimum distance of 700 mm and a maximum cooker hood (S) distance of 1300 mm. The following minimum safety Please be aware that if positioned too distance must be maintained high, extraction will be inefficient.
Installation – If the cooker hood is being installed in a suspended ceiling, the installation surface all around the cooker hood must be at least 300 mm larger than the cooker hood itself. Installation instructions – See the enclosed Installation sheet for instructions on how to install this appliance.
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as...
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue.
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the fan, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit ...with air extraction with external motor:...
Electrical connection If the switch is not accessible after installation (depending on country), an All electrical work should be undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual...
Operation with Control module DSM 400 The Miele DSM 400 control module Components used in the central (optional accessory) can be used to ducting system are not supplied by combine the cooker hood with other Miele. components. If in any doubt, the advice of a...
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –...
Weight Conformity can be obtained from the DA 2900....24.9 kg address on the back page. DA 2900 EXT ....19.0 kg Edge extraction panels DRP 2900 Glass .