Page 1
Operating and installation instructions Refrigerator K 2202 S-1 To avoid the risk of accidents or damage to the appliance, it is essential to read these operating instructions before it is installed or used for the first time. M.-Nr. 06 254 960...
Description of the appliance a Shelves d Butter and cheese compartment b Condensate channel and e Egg tray drain hole f Door shelf c Fruit and vegetable containers g Temperature selector and interior light with contact switch h Bottle shelf...
Caring for the environment Disposal of the packing Disposal of your old appliance material Please ensure that the appliance presents no danger to children while The transport and protective packing being stored for disposal. has been selected from materials which are environmentally friendly for It should be unplugged or disposal, and can normally be...
Warning and Safety instructions Technical safety This appliance complies with all This appliance contains the coolant relevant legal safety requirements. Isobutane (R600a), a natural gas Improper use can, however, present which is environmentally friendly. a risk of both personal injury and Although it is flammable, it does not material damage.
Page 7
Warning and Safety instructions Before connecting the appliance to persons could be dangerous and the the mains supply make sure that manufacturer will not be held liable. the rating on the data plate Ensure current is not supplied to the corresponds to the voltage and appliance until after maintenance or connected load of the household...
Page 8
Warning and Safety instructions Observe the "use by" dates given The appliance is designed for use on food to avoid the risk of food within certain climate ranges poisoning. (ambient temperatures), and should not Storage times will depend on several be used outside this range.
Page 9
Warning and Safety instructions Disposal of your old appliance Before disposing of an old appliance, first make the door latch or lock unusable. This way you will prevent children from accidentally locking themselves in and endangering their lives. Disconnect the appliance. Cut off the cable and render any plug unusable.
How to save energy Normal energy consumption Increased energy consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source Situated near to a heat source (radiator, oven).
Page 11
How to save energy Normal energy Increased energy consumption consumption Defrosting Defrost the freezer when a layer of A layer of ice hinders the cold ice one centimetre thick has built from reaching the frozen food, and causes an increase in energy consumption.
Switching on and off Before using for the first time Switching off for longer periods of time ^ Clean the inside of the appliance and the accessories with warm water and If the appliance is not going to be used a little washing up liquid, and then for a longer period of time, e.g.
The correct temperature It is very important to set the correct Please note the following: temperature for storing food in the – bathwater and other household appliance. Micro-organisms will cause thermometers are not very accurate. food which is not stored at the correct It is best to use an electronic temperature to deteriorate rapidly.
Using the refrigerator efficiently Different storage zones Do not store explosive materials in Due to the natural circulation of the air the appliance or any products in the appliance, there are different containing propellants (e.g. spray temperature zones in the refrigerator. cans).
Using the refrigerator efficiently Storing food correctly Store food covered or packaged. This will prevent food smells or tastes from affecting other foods, and prevent food from drying out and also any cross-contamination of bacteria. The growth of bacteria, such as salmonella, can be avoided by setting the correct temperature and maintaining good standards of hygiene.
Adjusting the interior fittings Moving the shelves Adjusting the door shelves ^ Push the door shelf upwards, then The shelves can be adjusted according to the height of the food. remove it by pulling it forwards. ^ Pull the shelf forward as far as it will ^ Replace the door shelf at the go;...
Automatic defrost Condensate and frost can build up on the back wall of the refrigerator whilst it is in use. These are automatically removed and defrosted by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the back of the appliance.
E-Cloth ^ A microfibre "E-Cloth" is available The data plate located inside the from the Miele UK Spare Parts appliance must not be removed. It Department which is suitable for contains information which is cleaning surfaces such as stainless...
Cleaning and care Door seal Do not use any oils or grease on the door seal as these will cause the seal to deteriorate and become porous over time. The door seal should be cleaned regularly with clean water and then wiped dry with a soft cloth.
^ Check that the fuse is not defective and that the mains fuse has not blown. If it has, contact the Miele Ser- vice Department..the temperature in the refrigerator is too low.
Page 21
^ Clean the condensate channel and drain hole. If you still cannot remedy the fault having followed these suggestions, please contact the Miele Service Department. To prevent unnecessary loss of temperature it is advisable not to open the door while waiting for the...
Noises Normal noises What causes them Humming noise made by the motor (compressor). This noise can Brrrrr... get louder for brief periods when the motor is switching on. Blubb, blubb..A gurgling noise can be heard when coolant is circulating through the pipes.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer – the Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
Electrical connection Electrical connection U.K. Non-rewireable plugs (BS 1363) All electrical work should be carried out The fuse cover must be re-fitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person in accordance with local and is lost, the plug must not be used until a national safety regulations.
Installation Do not place any appliance which Climate range Ambient room temperature gives off heat, such as a toaster or microwave oven, on top of this +10 °C to +32 °C +16 °C to +32 °C appliance, as this would increase +18 °C to +38 °C the appliance’s energy consumption.
Installation Fitting the handle Aligning the appliance If the door hinging does not require changing, the handle should now be fitted to the door. ^ To align the appliance adjust the feet using the spanner supplied. ^ Secure handle a to the holes in the door using screws b.
Changing the door hinging ^ Remove stoppers f, and unscrew The appliance is supplied right hand handle g. Refit the handle and hinged. If left hand door hinging is required, follow the instructions below. stoppers on the other side of the door.
Building under The appliance can be pushed underneath a worktop run. If this is done, then the top lid to the appliance may need to be removed: ^ Remove screws a from the rear of the appliance. ^ Lift the appliance lid up at the rear and then pull it towards the front of the appliance to remove it.
Page 32
Alteration rights reserved / 3305 M.-Nr. 06 254 960 / 01 en / GB K 2202 S-1...