Advertisement
Quick Links
Owner's Manual
[
I
I,CR"FTS"nNI!
Folding Miter Saw Stand
Stock No.
22200
HTC Products
• Safety
• Assembly
• Operation
• Parts
CAUTION:
Before using this product, read this manual and follow
all its Safety Rules and Operating
Instructions.
SEARS, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
Visit our Craftsman
Website: www.sears.com/craftsman
Advertisement
Related Manuals for Craftsman 22299
Summary of Contents for Craftsman 22299
- Page 1 HTC Products • Safety • Assembly • Operation • Parts CAUTION: Before using this product, read this manual and follow all its Safety Rules and Operating Instructions. SEARS, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. Visit our Craftsman Website: www.sears.com/craftsman...
- Page 2 Congratulations You have just purchased a 22299 Folding Miter Saw Stand. This product has been specifically designed to assist you in the use of your 10-12" miter saw. Parts Figure, "_ _Snap Button RightLeg (rear)_ LeftLeg (front) ModelNumber 22299 ffl'Y ModelNumber 22299 5096...
-
Page 3: General Safety Instructions For Power Tools
General Safety Instructions for Power Tools Using power tools of any kind can be dangerous if safe operating procedures are not followed. Recognizing the hazards of each tool and using them with respect and caution will considerably limit the possibility of personal injury. However, if safety precautions are ignored, personal injury will likely result. - Page 4 Assembly Instructions Read all assembly instructions completely before attempting assembly. See parts list on Page 2 for names and pictures of parts. Figure 1. _Weld identify all components and hardware. Figure 2 Place top frame upside down on your workbench or work surface. Position so that the nuts welded to the top of the frame tubes will be positioned in the lower right and upper left when the frame is turned over for assembly.
- Page 5 Attach the left curved legs to the frame using (1) 1/4"- 20 x 2" carriage bolt, (1) 5/16" flat washer and (1) 1/4"- 20 Nylok nut per leg. Use the hole which is second from the right, closest to the frame tube to attach the leg. Pass the bolt through the flat washer, then through the hole in the outside of the frame, through the top hole in the leg, through the bracket on the inside of the frame, and secure with 1/4"- 20 Nylok nut.
- Page 6 Carefully lift the saw with the attached extrusions and place onto the leg/frame assembly, Adjust the saw front/back along the extrusion to balance the saw on the frame. The mounting hook and clamp angle can also be adjusted to further balance the saw, and to equally space the mounting brackets along the extrusion.
- Page 7 Set-up / Knockdown Procedure Be sure the saw is positioned to the extreme left on the frame and securely tightened. Starting with the legs at the wheel end (left), depress the snap buttons to release the legs. Figure 17 Carefully walk the frame and saw down to the floor while allowing the legs to fold under.
- Page 8 Get it fixed, at your home or ours! Your Home For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories owner's manuals that you need to do-it-yourself.