Installation Procedure ¤ 1. To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the • If the power is not turned ON (or it is ON, but will be OFF battery. immediately), the speaker wire may have a short-circuit 2.
Page 4
Connect to the terminal that is grounded when either Mute wire (Brown) the telephone rings or during conversation. To connect the Kenwood navigation system, consult your navigation manual. Power control/ Motor antenna control wire Connect either to the power control terminal when using the optional (Blue/White) power amplifier, or to the antenna control terminal in the vehicle.
Connecting Wires to Terminals 2WARNING Connector Function Guide Pin Numbers for Cable Colour Functions Connecting the ISO Connector ISO Connectors The pin arrangement for the ISO connectors depends on External Power the type of vehicle you drive. Make sure to make the proper Connector connections to prevent damage to the unit.
System Connection USB terminal (iPod) USB device (commercially available) USB terminal USB device (commercially available) iPod Do not connect. To Relay Box Accessory 2 Rear view ■ Audio/Visual input2 • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) ■...
Installation for Monitor/Player Unit Firewall or metal support Screw (M4X8) (commercially available) Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Self-tapping screw Metal mounting strap (commercially available) (commercially available) Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip).
Removing Monitor/Player Unit Removing the Hard Rubber Frame Removing the Unit (escutcheon) 1. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the 1. Engage the catch pins on the removal tool 3 and Hard Rubber Frame>.