Table of Contents
Advertisement
UNPACKING
This product requires assembly.
[] Carefully lift the saw from the carton and place it on a
level work surface.
[] Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected and satisfactorily
operated the tool.
[] The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
[] If any parts are damaged or missing, please call
1-800-932-3188
for assistance.
_,
WARNING:
If any parts are damaged or missing,
do not operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
A
WARNING:
Do not attempt to modify this tool
or create accessories not recommended
for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING:
Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
A
WARNING:
Never stand directly in line with the
blade or allow hands to come closer than 3 in. to the
blade. Do not reach over or across the blade. Failure
to heed this warning can result in serious personal
injury.
A
WARNING:
To avoid serious personal injury, always
make sure the table saw is securely mounted to a
workbench or an approved leg stand. NEVER oper-
ate the saw on the floor.
MOUNTING
HOLES
The table saw must be mounted to a firm supporting,
waist high surface such as a workbench
or leg stand.
Four bolt holes have been provided in the saw's base for
this purpose. Each of the four mounting holes should be
bolted securely using 1/4 in. machine bolts, lock washers,
and hex nuts (not included). Bolts should be of sufficient
length to accommodate
the saw base, lock washers, hex
nuts, and the thickness of the workbench. Tighten all four
bolts securely.
Carefully check the workbench
after mounting to make
sure that no movement can occur during use. If any tip-
ping, sliding, or walking is noted, secure the workbench to
the floor before operating.
TO INSTALL
THE HANDLE
ASSEMBLY
See Figure 6.
[] Lift the end cap off the handle assembly using a flat
blade screwdriver.
[]
Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle or the
washer from the end of the screw.
[] Place the nylon nut into the recessed hole on the back
of the height/bevel adjusting handwheel and hold in
place.
[] Slide the handle, screw, and washer into the hole on
the height/bevel
adjusting handwheel.
[] Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
[] Push the end cap back in place on the end of the
handle.
NUT
END
HANDLE
CAP
ASSEMBLY
15
HEiGHT/BEVEL
ADJUSTING
HANDWHEEL
Fig. 6
- Quick Links:
- Features
- Assembly
- Makinga Dado Cut
- Adjustments
- Accessories
- Maintenance
- Parts List
Hide quick links:
Advertisement
Table of Contents
