Table of Contents
Advertisement
Quick Links
Software License, Warranty, Safety, and Regulatory Information — SBV5322 SURFboard
SAFETY AND REGULATORY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS — when using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
•
Read all of the instructions listed here and/or in the user manual before you operate this device. Give particular attention to all safety precautions. Retain the instructions for
future reference.
•
This device must be installed and used in strict accordance with manufacturer's instructions as described in the user documentation that is included with the device.
•
Comply with all warning and caution statements in the instructions. Observe all warning and caution symbols that are affixed to this device.
•
To prevent fire or shock hazard, do not expose this device to rain or moisture. The device must not be exposed to dripping or splashing. Do not place objects filled with
liquids, such as vases, on the device.
•
This device was qualified under test conditions that included the use of the supplied cables between systems components. To ensure regulatory and safety compliance, use
only the provided power and interface cables and install them properly.
•
Different types of cord sets may be used for connections to the main supply circuit. Use only a main line cord that complies with all applicable device safety requirements of
the country of use.
•
Installation of this device must be in accordance with national wiring codes and conform to local regulations.
•
Operate this device only from the type of power source indicated on the device's marking label. If you are not sure of the type of power supplied to your home, consult your
dealer or local power company.
•
Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or
cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.
•
Route power supply cords so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords where they are
attached to plugs and convenience receptacles, and examine the point where they exit from the device.
•
Place this device in a location that is close enough to an electrical outlet to accommodate the length of the power cord.
•
Place device to allow for easy access when disconnecting the power cord of the device from the AC wall outlet.
•
Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully inserted with no part of the blades exposed.
•
Place this device on a stable surface.
•
Avoid damaging the cable modem with static by touching the coaxial cable when it is attached to the earth-grounded coaxial cable-TV wall outlet.
•
Always first touch the coaxial cable connector on the cable modem when disconnecting or re-connecting USB or Ethernet cable from the cable modem or user's PC.
•
It is recommended that the customer install an AC surge protector in the AC outlet to which this device is connected. This is to avoid damaging the device by local lightning
strikes and other electrical surges.
•
Postpone installation until there is no risk of thunderstorm or lightning activity in the area.
•
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. For added protection for this
device during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the cable system. This will
prevent damage to the product due to lightning and power surges.
•
Do not use this product near water for example, near a bathtub, washbowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
•
Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal
instructions.
•
Disconnect the TNV circuit connector before removing the cover.
•
Disconnect TNV circuit connector(s) before disconnecting power.
•
Do not use the telephone to report a gas leak in the vicinity of the leak.
•
CAUTION: To reduce the risk of fire, use only No. 26 AWG or larger UL listed or CSA certified telecommunication line cord, or national equivalent.
•
Do not cover the device, or block the airflow to the device with any other objects. Keep the device away from excessive heat and humidity and keep the device free from
vibration and dust.
•
Wipe the device with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do not spray cleaners directly on the device or use forced air to remove dust.
•
Upon completion of any service or repairs to this device, ask the service technician to perform safety checks to determine that the device is in safe operating condition.
•
Do not open the device. Do not perform any servicing other than that contained in the installation and troubleshooting instructions. Refer all servicing to qualified service
personnel.
SAVE THESE INSTRUCTIONS
Note to CATV System Installer - This reminder is provided to call the CATV system installer's attention to Section 820.93 of the National Electric Code, which provides
guidelines for proper grounding and, in particular, specifies that the Coaxial cable shield shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
®
Digital Voice Modem
Advertisement
Table of Contents
Related Manuals for Motorola SBV5322 SURFBOARD DIGITAL VOICE MODEM - SOFTWARE LICENSE WARRANTY SAFETY AND REGULATORY INFO
Summary of Contents for Motorola SBV5322 SURFBOARD DIGITAL VOICE MODEM - SOFTWARE LICENSE WARRANTY SAFETY AND REGULATORY INFO
- Page 1 Installation of this device must be in accordance with national wiring codes and conform to local regulations. • Operate this device only from the type of power source indicated on the device’s marking label. If you are not sure of the type of power supplied to your home, consult your dealer or local power company.
-
Page 2: Caring For The Environment By Recycling
• If the battery leaks fluid and you touch it, immediately wash your hands. If the fluid gets into your eye, do not rub the eye. Rinse with water and immediately seek medical care. Left untreated, the battery fluid could cause damage to the eye. -
Page 3: Important Voip Service Information
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. -
Page 4: Fcc Declaration Of Conformity
Inc. Connected Home Solutions Business, 101 Tournament Drive, Horsham, PA 19044, 1-215-323-1000, declares under sole responsibility that the product identifies with 47CFR Part 2 and 15 of the FCC Rules as a Class B digital device. Each product marketed is identical to the representative unit tested and found to be compliant with the standards. -
Page 5: Software License
TRANSFER the Software (including all component parts and printed materials) permanently to another person, but only if the person agrees to accept all of the terms of this License. If you transfer the Software, you must at the same time transfer the Product and all copies of the Software (if applicable) to the same person or destroy any copies not transferred. -
Page 6: Warranty Information
Product, you assume full responsibility for the selection of the Product for its installation and use. While every reasonable effort has been made to insure that you will receive a Product that you can use and enjoy, Motorola does not warrant that the functions of the Product will meet your requirements or that the operation of the Product will be uninterrupted or error-free.