Table of Contents
Advertisement
Available languages
Available languages
Completing setup and connecting the power cord
1.
Unlock the casters and move the printer to its final location. Lock the casters after moving the printer.
Note: The casters are only meant for moving the printer a short distance over smooth surfaces.
2.
Remove any packing tape and plastic film from the exterior of the printer.
3.
Open the roll paper cover and remove the tape and packing material.
4.
Open the maintenance cover and remove the tape and packing material.
Caution: Be careful not to trap your hands or fingers when opening or closing the cover. Failure to do so could result in an injury.
Note: Make sure you save the packing material in case you need to ship the printer.
5.
Close the covers.
6.
Connect the power cord to the AC inlet on the back of the printer.
7.
Plug the power cord into a properly grounded electrical outlet.
Caution: Do not use an outlet that is controlled by an automatic timer or wall switch. Otherwise, you may accidentally shut off the printer
and cause damage to the printhead.
Completing setup and connecting the power cord
23
Advertisement
Table of Contents
