Advertisement
Quick Links
ACCUDUAL
ACS-75231/75241 RAID box
Quick Installation Guide
Package Contents
ACS-75231 or 75241 RAID Box
Power-delay module
Two identical keys for disk carrier
Power cord for connecting RAID box and power-delay module
Familiar with RAID box
Over view
ACS-75231/75241 is a reliable and affordable solution for RAID 1 disk
mirroring. The RAID box mirrors data to two hard drives in RAID box
simultaneously, and delivers optimized performance. And featuring intelligent
online recovery, the RAID box lets you hot swap a failed hard drive and
automatically rebuild the data to the new hard drive without any system down
time. The RAID box also provides the high flexibility in system interface support
both SCSI (ACS-75241) and traditional IDE (ACS-75231) (Also known as
P-ATA).
ACS-75231/ACS-75241 RAID BOX
ver1.0
1
Advertisement
Related Manuals for AccuDual ACS-75231
Summary of Contents for AccuDual ACS-75231
- Page 1 Power cord for connecting RAID box and power-delay module Familiar with RAID box Over view ACS-75231/75241 is a reliable and affordable solution for RAID 1 disk mirroring. The RAID box mirrors data to two hard drives in RAID box simultaneously, and delivers optimized performance. And featuring intelligent...
- Page 2 When a RAID1 member disk fails, array management simply directs all application requests to the remaining disk. RAID1 is suitable for data which reliability requirements are extremely high, or for data to which high performance access is required. ACS-75231/ACS-75241 RAID BOX...
- Page 3 ACCUDUAL Front view of ACS-75231/75241 RAID box: The LED indicators that are built in right-side of drive tray for indicating hard drive status. Please refer to below table for all status in details. When hearing the beeper sounds “bi-bi-bi”, please check the indicator status and react to the event immediately.
- Page 4 ACCUDUAL Rear view of RAID box: Recognize the type of your RAID box by checking the rear of RAID box. ACS-75231: Standard IDE (PATA) 40-pin interface IDE interface: Connector for 40-pin IDE interface cable IDE configuration jumper group ...
- Page 5 *The ID 7 usually reserved for SCSI host controller, please avoid using ID 7 OFF ON OFF ON OFF ON OFF ON for ACS-75231 box for preventing the OFF OFF ON ON OFF OFF ON ON conflict. OFF OFF OFF OFF ON ON ON ON...
- Page 6 If you intend to configure the device to other setting, please remove change according instruction figure. Mount or Remove hard drive 1 Slide hard drive into the disk tray firmly. 2 Mount the disk by screws from bottom of tray. ACS-75231/ACS-75241 RAID BOX...
- Page 7 ACCUDUAL Install ACS-75231/75241 into system Follow the following instructions to establish the connection. 1. After fully configured RAID box. 2. Power down your host computer. 3. Mount the RAID box into the system. 4. Connecting the SCSI/IDE cable from system computer to RAID box.
- Page 8 Note If you have installed non-identical hard drives, your computer will recognize RAID box as a single hard disk with a capacity equal to the smaller hard disk drive installed in the RAID box. ACS-75231/ACS-75241 RAID BOX...