Advertisement
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Warning!
instructions
automatic
start-up
1. SAFETY
1.1.
ELECTRICAL SAFETY
‰
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of
appropriate safety devices. A Residual Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. You
must also read and understand the following instructions concerning electrical safety.
9
Ensure that cables are always protected against short circuit and overload.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections
to ensure that none are loose.
9
Ensure that the voltage marked on the appliance matches the power supply to be
used and that the plug is fitted with the correct fuse - see fuse rating at right.
8
DO NOT use worn or damaged cables, plugs or connectors. Have any faulty item repaired or
replaced immediately by a competent electrician.
9
It is recommended that this heater is wired directly to a fused isolator switch. If, however, a plug
is fitted, the following applies:
9
Fit a new plug according to the following instructions (UK only).
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
d) After wiring, check that there are no bare wires, that all wires have been correctly connected,
that the cable restraint is tight.
1.2.
GENERAL SAFETY Read instructions carefully. Read and follow all instructions. Place instructions in a safe place for future reference.
DO NOT allow anyone who has not read these instructions to assemble, light, adjust or operate the heater.
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss
9
of life.
Check that the heater is in sound condition and good working order. Servicing must be performed by qualified operatives only.
9
Take immediate action to repair or replace damaged parts. Use recommended parts only. Unapproved parts may be dangerous and
will invalidate the warranty.
9
Only use clean kerosene or diesel (NOT BIO-DIESEL) to fuel your heater, in accordance with instructions contained in this manual.
‰
WARNING! Only use heater in well ventilated areas. Ensure continuous ventilation from outside of the building is provided to the
heater operating area. Refer to 5.2 Installation Maximum OPening Size. Unvented portable heaters use air (oxygen) from the area in
which it is used. Adequate combustion and ventilation air must be provided.
‰
WARNING! DO NOT store or use compressed air cylinders, petrol or other flammable liquids/gases in the vicinity of this or any other
appliance.
‰
WARNING! fire, burning and inhalation hazard. Keep solid combustibles such as building materials, paper and cardboard away from
the heater. Never use the heater in spaces which do or may contain volatile or airborne products such as petrol, solvents, paint thinner,
dust particles or unknown chemicals.
‰
WARNING! Direct fired heaters may cause carbon monoxide (CO) poisoning when incorrectly used e.g. indoors without adequate air
circulation, or if not working properly. CO poisoning may lead to death.
8
DO NOT use the heater in closed rooms, living areas, basements or below ground level.
8
DO NOT allow untrained persons to operate the heater and DO NOT operate the heater without the cover.
8
DO NOT move or handle the heater when hot.
8
DO NOT leave the heater unattended when in use. Switch the heater off and unplug from the mains before leaving work area.
8
DO NOT fill the fuel tank whilst the heater is running or still hot.
8
DO NOT overfill the fuel container. Wipe up any spilt fuel immediately.
8
DO NOT obstruct the air inlet (rear) and air outlet (front) of the heater. DO NOT use duct work in front or at the rear of the heater.
8
DO NOT look into the exhaust end of the heater.
8
DO NOT allow children or animals near the heater when in use, or while hot.
‰
WARNING! not for recreational vehicle use.
▲
DANGER! the front outlet is very hot during operation. DO NOT touch danger of burning.
‰
WARNING! RISK OF ELECTRIC SHOCK. DO NOT expose the heater to water spray, rain, dripping water or wind.
© Jack Sealey Limited
35/70,000BTU/HR SPACE WARMER® KEROSENE/
DIESEL HEATER WITHOUT/WITH WHEELS
AB350, AB708.V3, AB7081.V3
MODEL NO:
Warning!
Warning!
Hot surfaces
Original Language Version
Recommended fuse rating
AB350, AB708.V3, AB7081.V3 Issue:2(3) 24/05/22
13 Amp
Advertisement
Table of Contents
Related Manuals for Sealey AB350
Summary of Contents for Sealey AB350
- Page 1 AB350, AB708.V3, AB7081.V3 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
-
Page 2: Specification
Remove heater from carton. 4.2. If unit is damaged in any way DO NOT use and contact the Supplier. 4.3. Assembly for AB350/AB708.V3: Fix on the plastic handle (refer to Parts List). Assembly for AB7081.V3 refer to fig.1: 4.4. Insert the wheel shaft E into the corresponding hole of the caster fixing plate J. -
Page 3: Operating Conditions
DO NOT open the enclosure to clean the inner parts. DO NOT spray water into the heater. Never use solvents, gasoline, toluene and similar aggressive chemicals to clean the heater. AB350, AB708.V3, AB7081.V3 Issue:2(3) 24/05/22 Original Language Version © Jack Sealey Limited... - Page 4 If necessary adjust pressure to correct value by turning the adjusting screw (the air vent hole in the adjusting screw middle) clockwise to increase, anticlockwise to decrease the pressure. Model Air Pressure (bar) AB350 0.35 AB708.V3 0.32 fig.4 Original Language Version © Jack Sealey Limited AB350, AB708.V3, AB7081.V3 Issue:2(3) 24/05/22...
-
Page 5: Troubleshooting
Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...