GE Superadio (1) Manual
Re-typed in HTML format, remaining as faithful as possible to the original.
CAUTION: THIS MANUAL IS DESIGNED FOR USE BY QUALIFIED ELECTRONIC TECHNICIANS ONLY. CONSUMER
USERS ARE URGED TO CONTACT QUALIFIED FACTORY AUTHORIZED SERVICE FACILITIES FOR REPAIRS.
ELECTRICAL
BATTERIES
TUNING RANGE
IF FREQUENCIES
POWER OUTPUT
10% DISTORTION
SPEAKER IMPEDANCE
AM Generator - RF Radiated Signal Modulated 30% at 400 Hz
1.
2.
3.
4.
5.
High Side of FM Sweep Generator thry a 0.04uF capacitor to TP1, Use only enough Marker Signal for Indication.
1 of 6
FEATURES
Tuned RF on FM and AM improves reception
38" swivel whip FM antenna
7 7/8" ferrite rod AM antenna
4 IF tuned circuits on AM
AFC (Automatic Frequency Control) reduces FM drift
AFC defeat switch for fine tuning of adjacent stations
Precision vernier tuning
6 1/2" high sensitivity speaker
700mW RMS audio output
Separate bass and treble controls to personalize sound
Loudness control boosts bass at low listening levels
2-Way power with built-in AC cord
Automatic switching from AC to batteries
120
Volts AC, 60 Hz
9
Volts DC Battery
(6)
D Size Batteries
AM
530 kHz - 1610 kHz
FM
88 MHz - 108.3 MHz
AM
455 kHz
FM
10.7 MHz
mW RMS
700
Minimum
8
Ohm
AM ALIGNMENT - FUNCTION SWITCH IN AM POSITION
GENERATOR
RADIO DIAL
FREQUENCY
SETTING
455 kHz
Closed
1630 kHz
Open
510 kHz
Closed
1400 kHz
Tune to Signal
580 kHz
Tune to Signal
FM ALIGNMENT - FUNCTION SWITCH IN FM POSITION
SERVICE SPECIFICATIONS
SENSITIVITY
SELECTIVITY
MINIMUM VOLUME
HUM
CURRENT DRAIN
IDLE CURRENT
ALIGNMENT PROCEDURE
INDICATOR
ADJUST
T4, T5, T6, T9
C1L
Output Meter
L5
Across Speaker
C1J, C1K
T10, L6
http://earmark.net/gesr/sr1_manual.htm
MODEL
7-2880A
FM/AM
PORTABLE RADIO
FILE TAB 7
Better than 150 uV/M for
AM
20 dB quieting
Better than 25 uV (IHFM
FM
Sensitivity
65 dB (Minimu) for 2 ACA
AM
Selectivity
50 dB (Minimum) for 2 ACA
FM
Selectivity
5 mV
or Less
AM
20 mA Maximum
FM
26 mA Maximum
REMARKS
Adjust for maximum. Repeat
until no further improvement
is noted.
Adjust for maximum
Adjust for maximum. Repeat
steps 2 and 3 until set will tune
to both band end frequencies.
Adjust for maximum
Adjust for maximum. Repeat
steps 4 and 5 until no further
improvement is noted.
7/26/2014 3:34 PM