Intended use en Keep children below the age of Intended use 8 years old at a safe distance from the appliance and power This appliance is intended ■ cable. I n t e n d e d u s e for use in the home and domestic environments.
en Safety instructions If the dishwasher is installed Installation ■ below or above other Following installation, ensure domestic appliances, follow ■ that the back of the the information for dishwasher is not freely installation in combination accessible (protection with a dishwasher in the against contact due to hot installation instructions for surface).
Safety instructions en Install built-under or In daily use ■ integratable appliances only Read and observe the safety under continuous worktops information and instructions for which have been screwed to use on the packaging for adjacent cupboards to cleaning and rinsing agents. ensure stability.
Page 8
en Safety instructions Warning Warning Risk of injury! Risk of explosion! To prevent injuries, e.g. Do not add any solvents to the ■ caused by stumbling, open rinsing compartment. Danger of the dishwasher only briefly in explosion! order to load and unload the Warning dishwasher.
Safety instructions en Ensure that children do not Activate the child-proof lock ■ place fingers in the tablet (door lock) as follows: collecting tray 1B. Small Pull the catch of the fingers could become caught child-proof lock towards in the slots. yourself (1).
en Environmental protection Deactivate the child-proof lock Environmental (door lock) as follows: protection Press the catch of the child-proof lock to the right Both the packaging of new appliances (1). t e c t i o n E n v i r o n m e n t a l p r o and the old appliances themselves Press the catch of the contain valuable raw materials and...
Getting to know your appliance en Appliance interior Getting to know your See Fig. ~ Page 2 appliance 1" Interior light * 1* Cutlery drawer * Diagrams of the control panel and the y o u r a p p l i a n c e G e t t i n g t o k n o w 12 Top basket interior of the appliance can be found at...
en Getting to know your appliance Info button { Time setting The Info button { can be used to When the appliance is switched on the I n f o b u t t o n T i m e s e t t i n g display additional programme for the first time, the time starts at 12:00 information.
Getting to know your appliance en Switching on the appliance for the first time When the dishwasher is switched on for Change the setting as follows: the first time, you are taken directly to Keep pressing button > )* until the the settings for switching on the required setting is displayed.
en Getting to know your appliance Settings The dishwasher has been preset with Keep pressing button > )* until the certain settings for your convenience. required setting is displayed. You can change this factory setting. Make the setting with setting buttons + - X.
Water softening system/special salt en Setting Factory setting Infotext by pressing Info button { Timelight * While programme is running, status information is projected onto floor. Infolight * Light is projected to signal an active cleaning cycle. Start programme Eco 50° When switching on, the last selected programme appears.
en Water softening system/special salt Adjusting the water softening Using special salt system As soon as the low salt indicator P is lit on the control panel or is requested The amount of salt dispensed can be on the front display * ):, salt should set from 0 to 62°E.
Rinse aid en Using detergents with salt Top up the rinse-aid as follows: Open dispenser 9"; press lug on component the lid (1) and lift (2). If combined detergents with a salt s a l t c o m p o n e n t D e t e r g e n t w i t h a component are used, special salt can usually be omitted up to a water...
en Utensils Setting amount of rinse aid Utensils The amount of rinse aid to be Not suitable dispensed can be set from 0 to 6. Set U t e n s i l s the amount of rinse aid to be dispensed Cutlery and utensils made of wood.
Utensils en Loading the dishwasher Utensils must not be placed Note: above the tablet collecting tray 1B. These may block the lid of the detergent Remove large food remnants. It dispenser and prevent it from opening is not necessary to prerinse utensils fully.
en Utensils Heavily soiled utensils (pans) You can take out the cutlery drawer. Tip: should be placed in the lower basket. The more powerful spray jet provides a better dishwashing result. Other examples, such as the best Tip: way of loading your dishwasher, can be found on our homepage.
Utensils en Etagere * Folding spikes * The etagere and the space underneath * Depending on the features of your E t a g e r e F o l d i n g s p i k e s can be used for small cups and glasses dishwasher, the spikes can be folded or for larger items of cutlery, such as...
en Utensils Knife rack * Baking sheet spray head * * Depending on the features of your * depending on the features of your K n i f e r a c k y h e a d B a k i n g s h e e t s p r a dishwasher, the upper basket is fitted dishwasher with a knife shelf.
Utensils en Unloading the dishwasher Appliance height 86.5 cm With cutlery basket Upper Lower To prevent water from dripping off the basket basket upper basket onto the utensils in the Setting 1 max. ø 24 cm 34 cm lower basket, it is recommended to empty the appliance from the bottom Setting 2 max.
en detergent Upper basket with side levers Detergent Pull out upper basket 12. You can use tablets as well as powder Hold the sides of the basket along d e t e r g e n t or liquid detergents for dishwashers, but the upper edge.
detergent en Adding detergent Close cover on the detergent dispenser. Cover “clicks” into position. If the detergent dispenser 9* is still closed, actuate locking bar 92 to open it. Pour detergent into the dry detergent dispenser 9* only (insert tablet flat, not on its edge).
en detergent Combination detergent If programmes are short, tablets may ■ not have full cleaning effect due to Apart from conventional detergents different dissolving properties and (Solo), a number of products are offered there may even be undissolved with additional functions. These detergent residue.
Overview of programmes en Overview of programmes The max. possible number of programmes is illustrated in this overview. The a m m e s O v e r v i e w o f p r o g r corresponding programmes and their arrangement can be found on the fascia. Type of utensils Type of soiling programme Possible...
en Overview of programmes Type of utensils Type of soiling programme Possible Programme sequence additional options intensiveZone option Pre Rinse part dried, common Half load option Clean 50° Û mixed utensils household food HygienePlus Intermediate rinse and cutlery Night remnants extraDry Option Final rinse 63°...
Additional functions en Ï intensiveZone * Additional functions Perfect for a mixed load. You can wash i n t e n s i v e Z o n e very soiled pots and pans in the lower * Depending on the features of your i o n s A d d i t i o n a l f u n c t basket together with normally soiled...
en Operating the appliance AquaSensor * Operating the * depending on the features of your appliance A q u a S e n s o r dishwasher The Aqua sensor is an optical Programme data measuring device (light barrier) which p l i a n c e O p e r a t i n g t h e a p measures the turbidity of the rinsing...
Operating the appliance en Sensor setting AutoPowerOff (Switching off automatically after the end of The programme sequence is optmised the programme) in Auto programmes with the aid of sensors. The sensors adjust the To save energy, the dishwasher A u t o P o w e r O f f programme strength of Auto is switched off 1 minute after programmes depending on the amount...
en Operating the appliance TimeLight (Optical display Changing start programme while the programme is You can change the “Start programme” running) * setting. * depending on the features of your t i m e L i g h t dishwasher Tone volume While programme is running, an optical The end of the programme is indicated...
Operating the appliance en Eco drying Factory setting If you have selected the Eco 50° You can reset all settings to the factory programme, the door opens setting. automatically when the programme ends. This ensures a particularly Switching the appliance on economical drying result.
en Operating the appliance Time preselection Switching off the appliance You can delay the start of the Short time after the end of the programme by up to 24 hours. programme: Depending on the setting of the time Open the door. display, the end of programme is Switch off ON/OFF switch (.
Cleaning and maintenance en Terminating the programme Cleaning and (Reset) maintenance Open the door. p r o g r a m m e T e r m i n a t i n g t h e Press the START button )" and A regular inspection and maintenance hold for 3 seconds t e n a n c e...
en Cleaning and maintenance Filters Never use a steam cleaner to clean your dishwasher. The manufacturer The filters 1Z keep large foreign is not liable for any consequential objects in the rinsing water away from damage. the pump. hese foreign objects may Regularly wipe the front occasionally block the filters.
Fault, what to do? en Spray arms Fault, what to do? Limescale and contaminants in the rinsing water may block nozzles and Experience has shown that you can F a u l t , w h a t t o d bearings on the spray arms 1: and rectify most faults which occur in daily operation yourself.
en Fault, what to do? Waste water pump Check impeller wheel and remove any foreign objects. Large food remnants or foreign objects Place pump cover in the original which were not captured by the filters position (2) and press down until it may block the waste water pump.
Fault, what to do? en Fault table Fault Cause Remedial action Error code “:‚‰ is lit. Supply hose kinked. Install supply hose without kinks. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. 10 l/min. when water supply is open.
Page 40
en Fault, what to do? Fault Cause Remedial action Error code “:ƒ† is lit. Waste water pump blocked or Clean pump and lock cover correctly. cover on the waste water pump is ~ "Waste water pump" on page 38 not locked in position. Error code “:ƒˆ...
Page 41
Fault, what to do? en Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying. drying. ~ "Overview of programmes" on page 27 Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 42
en Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 43
Fault, what to do? en Fault Cause Remedial action Detergent residue. Detergent dispenser cover 9* Utensils must not be placed above the blocked by utensils and therefore tablet collecting tray 1B. These may does not open fully. block the lid of the detergent dispenser and prevent it from opening fully.
Page 44
en Fault, what to do? Fault Cause Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than 8.9...
Page 45
Fault, what to do? en Fault Cause Remedial action Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing temperature. Utensils precleaned too intensely; Do not prerinse utensils. Remove only sensors therefore decide on large food remnants. weak programme sequence. Increase sensitivity of the sensors.
Page 46
en Fault, what to do? Fault Cause Remedial action Appliance cannot be Malfunction. Disconnect appliance from the power switched on or operated. supply; pull out the mains plug or switch off the fuse. Wait at least 5 seconds, then connect the appliance to the power supply.
Page 47
Fault, what to do? en Fault Cause Remedial action Cover on the detergent Detergent dispenser or cover Remove detergent residue. dispenser cannot be guide blocked by sticky detergent closed. residue. Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate detergent dispenser 9* therefore detergent is not rinsed freely.
en Customer service Customer service Installation and connection If you are unable to rectify the fault, C u s t o m e r s e r v i c e please contact your customer service. The dishwasher must be connected We will always find an appropriate c o n n e c t i o n I n s t a l l a t i o n a n d...
Installation and connection en Delivery Installation Your dishwasher has been checked The required installation dimensions thoroughly in the factory to ensure that can be found in the installation it is in working order. This may cause instructions. Level the appliance with small water stains.
en Installation and connection Drinking water connection Warm water connection * * depending on the features of your Fasten the drinking water connection i o n W a r m w a t e r c o n n e c t dishwasher to the tap according The dishwasher can be connected...
Installation and connection en Electrical connection Transporting Empty the dishwasher and secure loose Connect the appliance to an ■ parts. alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz Drain the appliance according via a correctly installed socket with to the following steps: protective earth conductor.