Table of Contents
Advertisement
The Harnesses use one or both of the plug connector types detailed in Figure ENG-283-3: Harness Plug
Connectors. When connecting the plugs, ensure that the release button or buttons are depressed and
held until plug is fully connected or disconnected. Connecting or disconnecting plugs without
depressing and holding the release button or buttons will damage the plug.
Depress & Hold
[
Cable
Depress & Hold
11230_ART
Ensure that the harness cable lengths are long enough to make one complete run from the Station
Expander to:
•
the power supply
•
the remote station.
•
the Port and Starboard Processor
6
Tools For Installation
6.1
Required
•
Screwdriver – med. Phillips #2
•
Hole saw -- 1 inch (25,4mm)
•
Drills -- 9/32 inch (7,2mm) and 7/32 inch (5,6mm)
•
Saw (appropriate type of saw for cutting material Control Head will be mounted on)
6.2
Optional
Wire cutter, stripper, crimper (Recommend Thomas & Betts WT-2000) (if using single terminated
harnesses)
Page 6
4
Figure ENG-283-2: Station Expander Harness Connector Locations
Depress
&
Hold
11232_ART
Figure ENG-283-3: Harness Plug Connectors
2
5
Processor Key
15137_ART
MMC-343 Rev - 09/11
15138_ART
MMC-343 Rev - 09/11
Advertisement
Table of Contents
