Table of Contents
Advertisement
SYSTEM STARTUP
1.4 Standard Service Software Installation
START
Set the SENS switch
corresponding to the
system to have DATA
installed (CPU0, CPU1)
to "3" on the EMA card.
Make sure the write-protect
tab is set to "write enable
(permit)" position on the
"Standard Service
Software" FD. Note
Insert the FD "Standard
Service Software"
into the FDD.
Flip the MBR key on the CPR
[DOWN → UP → DOWN].
Slide the write-protect tab
to "write inhibit (protect)"
position on the "Standard
Service Software" FD. Note
END
Note:
Skip this step in the U.S.A, Canada and Australia.
Removal or Make Busy of the HFD
WARNING
card is not allowed while the Floppy
Disk or Hard Disk is being accessed.
CHAPTER 3
Page 22
Revision 1.0
<7-Segment LED Indication on the EMA card>
ND-70373 (E)
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
<Install End>
Advertisement
Table of Contents
