Page 1
CDX-3900R/4000R/4000RX 3 7 63 1515 0 SERVICE MANUAL AEP Model UK Model Photo: CDX-4000RX • The tuner and CD sections have no adjustments. Model Name Using Similar Mechanism CD Drive Mechanism Type MG-383Z-121//Q Optical Pick-up Name KSS-720A SPECIFICATIONS L 13942296513...
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. 4. EXPLODED VIEWS REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR 4-1. Chassis Section ..............40 IN SUPPLEMENTS PUBLISHED BY SONY.
http://www.xiaoyu163.com SECTION 1 GENERAL 3 7 63 1515 0 This section is extracted from instruction manual. L 13942296513 u163 http://www.xiaoyu163.com...
http://www.xiaoyu163.com SECTION 2 DISASSEMBLY 3 7 63 1515 0 Note : Follow the disassembly procedure in the numerical order given. 2-1. SUB PANEL ASSY 4 two claws 6 sub panel assy 2 PTT 2.6x8 3 claw 5 CN500 1 PTT 2.6x8 L 13942296513 2-2.
http://www.xiaoyu163.com 3 7 63 1515 0 2-3. MAIN BOARD 4 ground point screws 6 MAIN board (PTT 2.6x6) 5 ground point screws (PTT 2.6x6) 3 PTT 2.6x8 2 PTT 2.6x8 1 PTT 2.6x8 L 13942296513 2-4. HEAT SINK 5 heat sink 4 PTT 2.6x8 3 PTT 2.6x12 2 PTT 2.6x8...
http://www.xiaoyu163.com 3 7 63 1515 0 2-5. CHASSIS (T) ASSY 2 P 2x3 3 P 2x3 1 Unsolder the 4 chassis (T) assy lead wires. black white L 13942296513 2-6. LEVER ASSY 5 guide (disc) 6 lever (R) assy 3 tension spring (LR) 7 lever (L) assy 1 PS 2x4 2 DISC IN SW board...
http://www.xiaoyu163.com 3 7 63 1515 0 2-9. CHASSIS (OP) ASSY 7 chassis (OP) assy 8 compression spring (FL) 1 tension spring (KF1) 9 compression spring (FL) 2 tension spring (KR1) 5 Fit lever (D) in the direction of the arrow. 6 Turn loading ring in the direction of the arrow.
http://www.xiaoyu163.com SECTION 3 DIAGRAMS 3 7 63 1515 0 3-1. IC PIN DESCRIPTIONS • IC501 CXD2598Q (DIGITAL SERVO, DIGITAL SIGNAL PROCESSOR) (SERVO BOARD) Pin No. Pin Name Pin Description DVDD — Digital power supply pin DVSS — Digital ground SOUT Servo brock serial data output (Not used.) SOCK Servo brock serial data read clock output (Not used.)
Page 16
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Pin Description Tracking error signal input Center servo analog input RFDC RF signal input ADIO Test pin (Not used.) AVSSO — Analog ground IGEN Constant current input from OP amplifier. AVDDO —...
Page 17
http://www.xiaoyu163.com 3 7 63 1515 0 • IC5 CXP84640-063Q (CD SYSTEM CONTROL) (SERVO BOARD) Pin No. Pin Name Pin Description ITRPT — Not used in this set. 2, 3 — — Not used in this set. 4, 5 — Not used in this set. OPEN Front panel open detection input CLOSE...
Page 18
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Pin Description SENS SENS signal input — — Not used in this set. — — Not used in this set. BU.IN Back-up power detection input BUSON Bus on control input IN SW Disc in switch input (SW1) SELF SW...
Page 19
Not used. (Open) ILLON Illumination power control output — Power supply pin (+5 V) E2P SIO P SONY-BUS serial data input/output E2P CKO P SONY-BUS serial clock input/output SYSRST SONY-BUS system reset output DOORSW (WRITE OUT) DOOR OPEN/CLOSE detection input (“L”: CLOSE, “H”: OPEN)
Page 20
Key acknowledge input BUIN Backup voltage detection input ILLIN Illumination (ILLIN) detection input (Fixed at “L” in this set) TELATT Telephone (TEL) detection input (Fixed at “L” in CDX-3900R) — — Not used. (Open) TEST IN Test mode setting input...
CDX-3900R/4000R/4000RX 3 7 6 3 1 5 1 5 0 3-6. PRINTED WIRING BOARDS — CD MECHANISM SECTION — THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.) for schematic diagram: •...
CDX-3900R/4000R/4000RX 3 7 6 3 1 5 1 5 0 3-16. SCHEMATIC DIAGRAM — KEY SECTION — 1 3 9 4 2 2 9 6 5 1 3 w w w u 1 6 3 Note: • Voltage is dc with respect to ground under no-signal (detuned) condition.
http://www.xiaoyu163.com SECTION 4 EXPLODED VIEWS 3 7 63 1515 0 NOTE: • The mechanical parts with no reference • Color Indication of Appearance Parts The components identified by number in the exploded views are not supplied. mark 0 or dotted line with mark Example : •...
http://www.xiaoyu163.com 3 7 63 1515 0 4-5. CD MECHANISM SECTION (3) (MG-383Z-121//Q) M901 M902 L 13942296513 The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. Ref. No. Part No.
http://www.xiaoyu163.com SECTION 5 DISC IN SW ELECTRICAL PARTS LIST 3 7 63 1515 0 NOTE: • Due to standardization, replacements in • Items marked “*” are not stocked since The components identified by mark 0 or dotted line with mark the parts list may be different from the they are seldom required for routine service.