1.3.5 Check control panel button operation (function code: 13)
<Function>
This function is used to check that the buttons on the control panel operate normally.
<Operating Procedure>
(1) Press the [1], and then the [3] key in the initial state of maintenance mode. "00" is displayed
on the LCD.
(2) Press the buttons on the control panel according to the numbers provided in the figure
below.
Each time the button is pressed, the corresponding number is displayed on the LCD in
decimal notation. Check that the number displayed on the LCD matches the number
assigned to the button that has been pressed. If the buttons are pressed in the incorrect
order, "INVALID OPERATE" is displayed on the LCD. Press the
press the correct button.
(3) If the button operation is normal, the machine returns to the initial state of maintenance
mode when the last button is pressed. To cancel the operation and return to the initial
state of maintenance mode, press the
1.3.6 Save NetConfig data (function code: 18)
<Function>
This function is used to save NetConfig data to the USB flash memory.
<Operating Procedure>
(1) Press the [1], and then the [8] key in the initial state of maintenance mode.
"MAINTENANCE 18" is displayed on the LCD.
(2) Insert the USB flash memory into the USB terminal.
(3) Press the [SET] key. "NETCONFIG" is displayed on the LCD.
(4) Press the [SET] key. "SAVE TO USB" is displayed on the LCD.
(5) Press the [SET] key. "USB SAVING" is displayed on the LCD, and NetConfig data is
saved to the USB flash memory.
(6) "MAINTENANCE" is displayed on the LCD, and the machine returns to the ready state
of maintenance mode.
Create a folder named "NetConfig" in the USB flash memory and save the file as txt file.
button.
5-8
button, and then
1
2
3
Confidential