HP ProDesk 405 G1 Microtower Maintenance And Service Manual page 108
Hide thumbs
Also See for ProDesk 405 G1 Microtower:
- Specification (51 pages) ,
- Disassembly instructions manual (16 pages) ,
- Hardware reference manual (49 pages)
Table of Contents
Advertisement
Computer will not start.
Cause
Wrong memory modules were used in the upgrade or
memory modules were installed in the wrong location.
Power LED flashes Red five times, once every second, followed by a two second pause, and the
computer beeps five times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Memory is installed incorrectly or is bad.
Power LED flashes Red six times, once every second, followed by a two second pause, and the computer
beeps six times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Graphics card (some models) is not seated properly or is bad,
or system board is bad.
98
Chapter 7 Troubleshooting without diagnostics
Solution
1.
Review the documentation that came with the system to
determine if you are using the correct memory modules
and to verify the proper installation.
NOTE:
DIMM1 or XMM1 must always be installed.
DIMM1 must be installed before DIMM2, and DIMM3
must be installed before DIMM4.
2.
Observe the beeps and LED lights on the front of the
computer. Beeps and flashing LEDs are codes for specific
problems.
3.
If you still cannot resolve the issue, contact Customer
Support.
Solution
CAUTION:
To avoid damage to the DIMMs or the system
board, you must unplug the computer power cord before
attempting to reseat, install, or remove a DIMM module.
1.
Reseat DIMMs. Power on the system.
2.
Replace DIMMs one at a time to isolate the faulty
module.
NOTE:
DIMM1 or XMM1 must always be installed.
DIMM1 must be installed before DIMM2, and DIMM3
must be installed before DIMM4
3.
Replace third-party memory with HP memory.
4.
Replace the system board.
Solution
For systems with a graphics card:
1.
Reseat the graphics card. Power on the system.
2.
Replace the graphics card.
3.
Replace the system board.
For systems with integrated graphics, replace the system
board.
Hide quick links:
Advertisement
Table of Contents
